If the copper wires weren't cut or damaged, you can seal the insulation with nail polish and then wrap with electrician's tape
Ok the wire could have been rubbing against the hose clamp from engine vibrations and Rick got you covered here for the wire repair now to the no start condition because the output wire was making ground contact it's possible that you have a few blown fuses in the power distribution box and possible fuse link damage ///First Lisa you must do the wire repair and either Ricks method or solder it back together then heat shrink it and the tape a small piece or rubber hose around it for protection and if it was rubbing it will show up on the hose before a problem comes ///next check all fuses in the power distribution box and the cable end and lug and clean there contact points replace all blown fuses obviously ok //next try to start it if you found bad fuses next we need to check for spark at the plug wires ground to the engine or held just over the spark plug top if there's spark it will jump to the plug and you will see it //if not now look at the coil/s for voltage coming in and out if none your crank sensor /ignition module (( no year given )) could have blown from the grounding voltage from the alternator wire this will most likely damage the ignition module they ard problematic without this happening ok ///next post comming
Everything on a vehicle moves through temperature change or vibration and things that touch are apt to chafe and be damaged and it is amazing how often a soft material can wear away a harder material. This is a large part of the value of regular inspections.
If the wire conductor is undamaged, half a dozen layers of electrical insulation tape carefully and neatly applied will provide sufficient insulation though the adhesive it is not resistant to heat and will unwind over time so securing it with a small nylon cable tie will prevent that.
SOURCE: 2003 ford ranger dtc code index
hi there this code is a common problem with this engine
the dtc code p2004 is related intake manifold runner control it is stuck open bank 1a .
you need to replace controll switch
SOURCE: Misfire on 4, 5 & 6
Take your time, if its been awhile do a complete tune-up. and preliminary check a misfire can come from a defective cap and rotor, fuel and air filter. a leak in the fuel system or defective regulator.
SOURCE: '84 Ford Ranger cuts off after about 30 mins of driving.
sounds like the auto choke isnt turning itself off properly but to be totally honest i would need this to happen when i test drive it to diagnose it correctly .
SOURCE: Replaced wiring harness on 2000 Ford Ranger now truck won't start
2000 ford ranger wont start off switch if u jump the silanoid it will start. new start and ignition switch
322 views
Usually answered in minutes!
Ok Lisa if you have spark from the coil/s next spray gas or fuel injection cleaner into the throttle body if it runs and dies we know that there's a fuel delivery problem possibly before we go any further make sure the spark plug gaps are ok if not regap or replace them after this if the no start condition is still present try again with the spray if the same thing happens now it's 100% sure that there's a fuel problem when you get to this point of checking post back write everything down that you did and we'll take it further to get you running this could be an idle air control valve,fuel pump relay, driver module ,fuel pump or a clogged filter so post back and one of us will pick it up ok thanks stephen
×