SOURCE: 98 gmc suburban brake lights
One of two things cause this corroded or poor chassis earth at the bulb holders or the circuit board that holds the bulb is faulty.
SOURCE: Non working brake lights in Nissan Altima
make sure the button is working, it may need to be replaced. with your foot off the brake peddle, it is on upper part of brake peddle arm. when you let off brake peddle it pushes button in to shut lights off. it may just be stuck in, spray a little lubracant on it if it's stuck and push in manually several times to loosen.
SOURCE: 1999 cougar brake lights not working Fuse+bulbs+switch ok
I am asking you what switch you cheked and how did you know that is ok and working I had the same problem I replaced the switch under the brake pedal and it works fine if you still have this problem write to me @ [email protected] thank you good luck.
SOURCE: 99 Dodge Ram 1500 4x4 / nothing but parking lights,no flashers or brake lights......
I found the problem on my Dodge Ram van.. The button for the hazard lights was bad.. I tuned on the hazard lights and only had one side, so i jiggled it and the other side came on. Then I pushed in the hazard button to turn them off and proceeded to check the brake lights, the still did not work so I again jiggled the hazard button and whaaalaaa the brake lights would flicker on and off.. I have a piece of cardboard pushing the button to the side to hold pressure on it keeping my brake light connection until I can get me a new hazzard switch.. Hope this helps..
49 views
Usually answered in minutes!
×