SOURCE: 2009 kia sorrento lx 6 cyl 3.3l engine , where is
OK OIL FILTER IS A PAPER FILTER NOT A SCREW ON....ON TOP OF ENGINE YOU ARE GOING TO HAVE TO UNSCREW LID ON TOP ITS BLACK.ITS AT FRONT OF ENGINE. TRYED TO SEND PIC BUT WOULDNT GO THREW
Testimonial: "Thanks, After not finding it under the engine and saw the engine cover I assumed it would be a paper roll filter."
SOURCE: 2005 kia sorrento - what freon do I use?
This is a R-134a system and right around 1 .75 lbs should be planty for that system without going over and provide a nice icey cold vent. Let me know if you need anything else.
SOURCE: 2006 kia sorrento battery not
Sometimes when they check alternators it says that they are ok. But sometimes they are not. If the car dies and the lights go dim then it is going to be the alternator. But if the car runs fine and the battery is dead the next day or several hours later. Then there is something that is not turning off and draining the battery. If this is the case, the best way to find the problem is to take the fuses out and put them back in one by one. Whith the key off. You will get a spark when you find the one that is causing the problem. DC voltage will not spark unless it is under a load. And a load is what is killing the battery.
If this helps you please rate by checking the 4 thumbs up! Thanks for using Fixya.com
SOURCE: 2006 kia sorrento ac started
check you have a leak some where in the a/c system could be just a o ring went bad you can get leak dye at parts store and this will loc. the leak
SOURCE: fuel pump replacement on a 2003 kia sorrento
Remove negative battery terminal, release tank pressure by opening gas cap, remove the rear seat, you will see a cover, remove the cover, you will now see the top of the gas tank and also the pump, the pump is located inside the tank and can be removed from the top, next remove the connector from pump, remove the lines, note : cover lines with a rag as you remove there may be a little pressure, this will help gas from spray all over, with connector removed and lines removed you will now remove the six bolts holding the pump in, lift and remove the pump, take note of the position, make a ref mark so you can reinstall pump in top of tank facing the right way. this is called a fuel pump module, here is a picture of the pump unit.
44 views
Usually answered in minutes!
×