Rear wheel alignment 2006 Sonata LX V6 - Cars & Trucks

SOURCE: replacing rear wheel bearings on 1999 hyundai sonata

1. for drum brakes with sealed hub(all one piece) remove lug nuts and wheel.
2. spray penetrating oil around studs if there is a big phillips head screw visible remove it with impact driver/if not use big ballpeen hammer ,tap on flat of drum near studs(becareful not to hit them) until drum loosens(your creating a shockwave to loosen rust)
3. once drum is off there are 4-bolts coming in from behind backing plate, remove them then hub should be able to be removed w/a little persuation from hammer.

1. remove wheel
2. remove dust cap,cotterpin,star washer(if equipped) do not re use cotter pin
3. remove nut then washer, wiggle brake drum and front bearing will come out.
4. put nut on shaft tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft
5. to replace reverse procedure making sure to pack new bearings w/grease(take drum and use long punch to remove bearing races, use race/seal installer to install new races

1. remove wheel
2. remove caliper/bracket
3. remove rotor
4. remove 4-bolts from behind,tap old hub out
5. reverse procedure

SOURCE: front wheel alignment

thanks for your reply/update the reason for front tyres wearing as you describe would suggest the steering tracking is wrong and for some reason ?the tyre wear on inner isindication the track is toeing out too much ? this fault could be ? simple adjustment req'd however dependand on make of tyres has to be considered when tracking as to whether they toe in or out or straight ahead ? also front wheel drive ? there could be other factors b4 tracking is adjusted such as steering joints wear ? or damage ? also suspension ? as i mentioned best to visit a good tyre depot and let them investigate while you wait and give you a reportas to fault normally free in uk if it is simply tracking req's re adjust then they can do it and charge for the adjusting not expensive and they may also recommend switching wheels from rear to front providing tread are good ? hope this helps best wishes

SOURCE: which cylinder in #6 on a 2006 V6 hyundai sonata

Autozone.com says that for this vehicle the firing order is 1-2-3-4-5-6 and the set-up is 2/1 4/3 6/5 meaning that the #6 cylinder is far right on the back. It goes #1 #3 and #5 in the front and #2 #4 and #6 in the back.

SOURCE: How to i adjust the rear wheel alignment at

sir iwant p19u5gcm volume drives

Colin Stickland

• 22516 Answers
• Posted on Jul 21, 2010

SOURCE: what type of battery for a 2006 sonata lx v6

74 amp hour