There are two speed sensors, Input sensor is located on top of the bell house. Output sensor is located on the firewall side of the bell house.
SOURCE: turbine input speed sensor
NO the sensor is out side the transmission. And it might just be a bad connection due to being out in the eliments. On the 3.1 your going to have to jack up the car to get to it from underneath and you should see it on the passenger side may be on top, Sorry been awhile and carful not to brake the clips that hold the wire to the sensor when disconnecting.
Good luck and hope this helps
SOURCE: input/turbine speed sensor circuit
Your speed sensor, is located on top of the transaxle, near the starter. To access it, remove the battery, then remove the battery tray (4 10mm bolts). You will see wires coming from the lower oxygen sensor, and they snap into the bracket that holds the speed sensor in place. The actual speed sensor has a 2 wire clip on it, and is held in place by the bracket and a 10mm bolt.
SOURCE: 2000 Hyundai Sonata jerking and causing poor performance
The turbine shaft speed sensor can cause this problem, It is also know as the transmission input shaft speed sensor. It will cause the transmission to **** and also stick in 3rd gear, which wound cause slow acceleration.
SOURCE: turbine input shaft speed sensor circuit
both input and output speed sensor are located on the left side of the transaxle case. do not interchange input and the output sensor.
148 views
Usually answered in minutes!
×