SOURCE: need torque settings for 1985 4A corolla cylinder head
hey, torque must be done in 3 steps:
1st 22 ft lbs
2nd 43 ft lbs
final 47 ft lbs
use this sequence of tightening:
9 - 3 -1 -6 -8
7 - 5 - 2 -4 - 10
SOURCE: cylinder head torque settings 1990 2.6L isuzu motor
From front to back is this:
7 3 1 5 9
8 4 2 6 10
First torque value is 58 ft lbs.....then final torgue is 72 ft lbs.
SOURCE: 94 mazda B3000 3.0L cylinder head torque specs
Step 1 torque to 59 ft pounds
2. Loosen one full turn
3. 37 ft pounds
4. 68 ft pounds
Use torque sequence below
SOURCE: golf iv 1.6 8v cylinder head torque settings
hi to tighten you have to do it in 4 stages as follows
1st stage 40nm leave 5 mins
2nd stage 60nm leave 5 mins
3rd stage 90 degrees leave 10 mins
4th stage 90 degrees
then you are done i will try put order on here i hope this works as follows
10 4 2 6 8
front of engine back of engine
7 5 1 3 9
in that order hope this helps
SOURCE: I need the torque settings
cylinder head bolts:
step one: 22 Ft-lbs.
step two: tighten additional 90 degrees
step three: tighten additional 90 degrees
102 views
Usually answered in minutes!
×