Sounds like a loose wheel, check them ,
SOURCE: 2003 Hyundai Tiburon making a weird noise
Hello mpolci...The 2003 Tiburon was sold to the public with a defective clutch, it failed due to warpage and bad pressure plate... among other things. There are MANY class action lawsuits. Did you resurface or replace the flywheel when the clutch was replaced? Did you go with an aftermarket clutch kit, or factory? Also the slave cylinder on the 03 was known to have a defective valve.
You can try checking the levels and bleeding the system and if you still have problems, then it could
be a release bearing, a loose clutch pad, or a broken pressure plate spring....If the clutch is still under warranty, i would return it to the installer.
Good luck, i hope this helps...please rate me a fixya.
SOURCE: My 2007 Toyota Corolla front wheel drive makes a
Possible axle shaft, or even a wheel bearing. Get it looked at.
SOURCE: I have an 02 impala
4T65E, Internal transmission failure, axle shaft is close but it is the differentail section of the transmission
SOURCE: Grinding noise....sounds like metal
Check the disk brake pads. At slower speeds you can hear them squeak because there is less wind and road noise. The other possibility could be a bad u joint at the ends of the axle half shafts on the front differential. Check both. I really doubt it is the transfer case. You transfer case is engaged all the time. The axle is locked and engaged when you flip the lever by a vacuum motor on the axle shaft on the differential.
SOURCE: I hear a loud grinding noise when i drive my car
Check front tyres & wheel bearings espesially the R/H/F. Feel tyre for high / low spots on inside & jack up & spin wheel if you get noise while jacked up it is not the tyres but wheel bearing or brake pads but more than likly a crook bearing by the sound of it. It needs to be tended to ASAP
43 views
Usually answered in minutes!
×