SOURCE: need to replace pulley for serpentine belt on a 2000 Eclipse
left need to use a air tool most likely
SOURCE: crank shaft bolt left or right hand thread on rav4
It's right hand thread, but very tight. One trick mechanics use, is to disable the igniton, and put a johnson bar on it, with it braced somewhere against a frame member, and crank the engine very briefly with the starter. The engine cranks clockwise so you must ready the bar against something in that direction. As you crank, the bolt resists in the counterclockwise direction and comes free. Sometimes makes a bit of noise, but it works like a charm.
SOURCE: Crankshaft pulley bolt on a 2000 Nissan X-terra
u turn counter clockwise to loosen, but you MUST USE a good quality air impact gun to get it loose.
SOURCE: 2002 Saturn SL2 crankshaft bolt removal
Look at rotation of harmonic balencer to remove bolt is in opposite direction.To remove bolt :Disconnect coil wire or wires so car will not start Next put socket on bolt with breaker bar and wedge bar some where solid on car. Bump motor with starter the small r turning of the starter will loosen bolt
SOURCE: need to know if the
Hi...I believe it is right handed thread. I don't know if you have the following but you might want to check this out:
http://www.autozone.com/autozone/accessories/Tools-Garage-and-Equipment/Harmonic-Balancer-Puller/_/N-2640
http://www.autozone.com/autozone/accessories/Tools-Garage-and-Equipment/Harmonic-Balancer-Installer/_/N-25qp
Auto Zone usually has these tools to loan!
Hope I helped,
over4dy
47 views
Usually answered in minutes!
×