SOURCE: 2004 wrangler blinker problem
What other problem did you have before the signals quit? Something that stopped all functions from the signals has to be either a feed or ground IF the flasher is good. Signals feed. Hot wire from the flasher 1 and it should blink underload, but not with a test light or DVM. In other words using a test light the flasher wire should be powered steady. All the rest of the switch is switchable. You should also get a hot wire when the brake pedal is pushed. Check for power at the brake switch,key off.
SOURCE: turn signals and flashers
Hello I had the same problem on my 04 monte. After changing bulbs ,checking wires etc. I finally took it to the dealer and they found out it was the hazard switch. After swapping it with a new one all lights, dash etc started working again and have not had another problem
SOURCE: Blinkers stopped working
Your F--150 has 2 flashers, emergency and turn signal. Both are mounted on the fuse block under the dash. The turn signal flasher is mounted on the front of the fuse panel, the emergency flasher is mounted on the rear of the fuse panel. so replace the turn signal flasher should solve the problem. Let me know how it goes.
SOURCE: blinker dont work flasher and other lights work
The turn signals don't work, but the emergency flashers do? If that's the case, replace the flasher, you have 2 flashers, one for emergency (hazard) flasher, and one for the turn signals. It should be on the fuse block under the dash.
SOURCE: All my blinkers and brake lights stopped working
PO430: Catalyst System Efficiency Below Threshold (Bank 2)
Here is a site that you should go to and further look at the common problems with your catylitic converter, and also your other emissions systems. Hope it helps, and please rate!!!
http://www.discountconverter.com/catalytic_converters_news/news_page.cfm?Key=codes-po420-po421-po430-po431&News=120
27 views
Usually answered in minutes!
×