Alternator bad or connection. Trade old one in at parts but the mainwire from the back to the batt may b worn..test that first by hooking a jumprcable in place..once car is started again
Did it run different before dying ?
Likely battery cell failed or charging system fail or bad bad connection at battery.
Check battery voltage is greater than 12.2 VDC.
If battery is ok then look for loose ground or positive cable.
SOURCE: where is the crank sensor located on 2005 chrysler pt cruiser?
the crank sensor is located on back right side of engine by were the trans. bolts up.is the no start when could or hot?
SOURCE: 2004 chrysler pt cruiser starter motor removal
You may sneak it out with small fingers with out pulling out the starter.
If starter removal is required,Just unhook the battery cables,Remove the 2 bolts holding the starter on.
Please rate this a fixya
SOURCE: my 2002 pt cruiser lost power steering suddenly
check to see if the serpantine belt is still there. It sounds like like it broke. this belt runs all of the accesories on the vehicle including the water pump. So if this happened it probably starting running hot too
SOURCE: 02 PT Cruiser LE w' Code P0340
My thought is to get a refund from the shop that tried to replace parts in order to secure your problem. The job of the shop is to diagnose the problem, not to replace items that may be the problem. Chrysler Master Techs are not trained to just replace parts, they fix the problem by diagnosing it properly.
You need to see a Chrysler dealership so they can attach a DRBIII and tell you exactly what is at stake.
I hope this helps you. I would be mad as heck.
I would not think the plugs and wires would be the problem because they would all have to fail at the same time to provide the symptom you experienced.
1. Get your money back
2. DRBIII
SOURCE: where is my crank sensor located on my 2004 pt
The crank sensor is on the lower rear side of the block.
77 views
Usually answered in minutes!
×