If it is the rear lights you might be able to loosen some winged nuts to drop the whole light fitting out to do it.
if it is the front lights there might be an access flap in the wheel arch to get to the bulb. You might be able to remove the entire wheel arch liner and get to it from underneath. If not you might have to remove the entire headlight to change it. Some car manufacturers fit the headlights with clip style mounts so you can tilt it for access.
SOURCE: how do aye get in2 my 2002 celica to change the bulbs
you have to take the bumper off to get to the lights
SOURCE: i need to know how to get the tail light lens cover off to change signal bulb
Open hatch and on inside of body where the lens is are two horizontal screws going into the lens, remove them and pull the lens towards the back of the vehicle carefully. Good luck
SOURCE: how do you take the cover off the break lights to change bulb
with the trunk open, there will be 2 or 3 screws holding the light assembly onto the car.. remove the screws and the assembly will pop out... then twist the socket in the back of the assembly and the light bulb will pop out
SOURCE: My brake light is out
I think you should see screws inside the trunk and on the back of your tail light then unscrew them and you'll be able to get the whole tail light out and then you can take the bulb out by turning the bulb cover. Good luck
SOURCE: ssangyong kyron fan belt
Sent me your e-mail address to [email protected] and I will mail you the correct diagram .
318 views
Usually answered in minutes!
×