Hey there, I have a question about my Ford Econovan Bj. 91 Patrol 2.0 Camper. I would like to adjust the valve clearance. In the owner's manual, I found that the engine should be brought to operating temperature before setting the valve clearance. I am looking for the setting values ?? for the inlet and outlet valve. maybe someone can help me @
Valve clearances are the small gaps between the tops of the valve stems and the part of the mechanism which presses on them to open the valves . Check the clearances at regular intervals as specified in the car service schedule, and adjust if necessary. Reset the clearances whenever the cylinder head has been removed.
https://www.howacarworks.com/engine/checking-and-adjusting-valves
SOURCE: Mazda pick up B 2900 valves clearance
THIS IS FOR A B3000 SERIES.
The manufacturer indicates that this vehicle has hydraulic lifters or adjusters and therefore does not require adjustment.
THIS IS FOR THE B2300 SERIES.
Midrange clearance is the most desirable:
Intake
0.22 - 0.28 mm (0.008 - 0.011 inch)
Exhaust
0.27 - 0.33 mm (0.010 - 0.013 inch)
"COULDN'T FIND B2900 SERIES"
SOURCE: Engine tappet clearances
According to http://freespace.virgin.net/tommy.sandham/databook.htm# Rocker Adjustment, the cold clearance is .008" intake/.018" exhaust in the non-GT 1500cc, and .012" intake/.022 exhaust on the GT. Sweet little car!!!
SOURCE: Head stud torque
cyl head torqes.1st stage 29 nm. 2 nd stage 57-67 nm. 3rd stage slacken off 360 cegrees, 4th stage 29 nm. 5th stage 64-74 nm. intake and exhaust valve clearance .38 mm hot setting. hope it goes ok.
SOURCE: valve clearances for a ford econovan 1.8lt, 1990
what are the valve clearance specs for a 1990 ford econovan maxi
SOURCE: i have to adjust valve
What engine do you have (size)? Valve adjustment is generally a thing of the past after the introduction of hydraulic lifters (no adjustment). In 1994 your engine should have hydraulic lifters and are not adjustable. Is this a high performance engine? New camshaft, lifter, and rocker set that are adjustable?
304 views
Usually answered in minutes!
Hello, sorry i found it. It's 0,3 mm for intake and exhaust. Thanks a lot
×