Location of crank position sensor 5.9l v8 dodge ram 2500

Question edited for clarity and add maker.
Question moved to model category.

In the link

Fuse Box Diagram Dodge Ram 1500/2500 (2002-2009)

https://fuse-box.info > dodge > dodge-ram-1500-2500-...

Fuse box diagram (location and assignment of electrical fuses) for Dodge Ram / Ram Pickup 1500/2500 (2002, 2003, 2004, 2005, 2006, 2007, 2008, 2009).

..

Hi Michael, The link below is a short YouTube video showing how to find a crank shaft position sensor on a (1998 dodge Dakota v8) I know it's not a 1998 dodge ram v8 but the motors should be similar, I hope this helped..........CHEERS..
https://www.youtube.com/watch?v=CfbYBb9GWhA
1998 dakota crank position sensor repair August 2011

well if ur not getting spark and u changed all of the ignition components lets think about the computer in order for the ignition to work you have crankshaft position sensor that fires the fuel injectors and the spark change that and if still nothing then change the camshaft postion sensor that sensor tells the computer that the 1 piston has came all the way up and it tells the crankshaft sensor to do its thing

The crank sensor on the truck works with the camsensor the crank sensor uses the cam to synchronize and identify where number one piston position is at. It is responsible to fire you injector and for how long is determined by the cam position sensor. On a 96 Dodge diesel the crank sensor is also responsible for you tach reading,your air condition ,and for the alternator.

check engine light and code P1391 crank or cam position sensor

The above can cause rough idle on the Dodge Ram 1500 5.2L V8 Engine.

Can try to replace the sensor, but verify that the wires are ok first.

Crank sensor is in the bell housing of the transmission. Cam sensor is in the distributor.

This could be a number of things...
Crank sensor, cam sensor, coil, PCM, spark control module, ect.
Start with the sparkplugs, make sure they are firing if not work your way back from there spark pligs, wires, coil, control module, cank and cam sensors, PCM this is what i would do if this rolled into my shop.

inline of air duct (plenum) after air filter

behind engine passenger side top of trani betwem block and trani simple to replace