How do i change a serpentine belt for a 5.7 2007 tundra
Drive Belt: Service and Repair
DRIVE BELT
Components
REMOVAL
1. REMOVE V-BANK COVER SUB-ASSEMBLY
2. REMOVE NO. 1 ENGINE UNDER COVER
how do i change a serpentine belt for a 2007 - 4cff58f.jpg="/uploads/images/4cff58f.jpg" alt="4cff58f.jpg" class="h_mi" />
3. REMOVE FAN AND GENERATOR V BELT
(a) While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and
then insert a bar of [diameter]5 mm (0.197 in.) into the service hole to fix the belt tensioner in place.
HINT: The pulley bolt for the belt tensioner has a left-hand thread.
(b) Remove the V belt.
1. INSTALL FAN AND GENERATOR V BELT
(a) Set the V belt onto every part.
(b) While turning the belt tensioner counterclockwise, remove the pin.
NOTICE: Make sure that the V belt is properly set to each pulley.
(c) After installing the belt, check that it fits properly in the ribbed grooves.
HINT: Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.
2. INSTALL NO. 1 ENGINE UNDER COVER
3. INSThow do i change a serpentine belt for a 2007 - c0b77ac.jpgCOVER SUB-ASSEMBLY
SOURCE: how do you replace the serpentine belt on a
one of the idler pulleys is spring loaded ,look carefully to see what one it is then look to see if it has a square drive to put a rachet bar in to release the tension.
SOURCE: how to change serpentine belt, 2004 Toyota Tundra
locate tensioner pulley; release tension from belt; remove belt; make sure not to forget how the belt is routed; route belt around all pulleys but tensioner; put tension on tensioner pulley; route belt over tensioner pulley
SOURCE: changing serpentine belt 3.8 2007 pontiac grand
SOURCE: Serpentine Belt routing diagram for 2007 Toyota
Installing fanbelt on 2007 Toyota Tundra 5.7
3,470 views
Usually answered in minutes!
×