Question about 2006 Ford F-150

1 Answer

2006 f150 keeps blowing turn signal fuse

20 amp fuse keeps blowing out for turn signals and brake lights

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 736 Answers

It sounds like the fuse is doing what it is supposed to do, and burning out when there is a short circuit. Check the wiring from the fuse block back to the lights and pay special attention to the trailer connection.

Posted on Oct 09, 2009

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Ford Ranger 10 amp fuse keeps blowing no brake lights,abs, turn signals?


Fuses blow because there is an overload on the system. If the fuse blows when you step on the brakes then there may be a short in the wiring from the brake light switch to the lights, abs module or turn signal switch. If the fuse blows when you turn the key on then there is likely a short in the wiring to the brake light switch. Basically you will need a wiring schematic to check the wires at the switch and at each of the loads. Also verify that the fuse is supposed to be a 10 amp fuse. Hope this helps

Mar 27, 2017 | Ford Cars & Trucks

1 Answer

Why does my turn signal/ hazard light fuse keep blowing out


you have a short in one of the light sockets or a worn wire from the wiring harness. could be the flasher assembly. are the turn signals different bulbs from the brake lights? Does using the brakes blow the fuse? (Rear lights or brake light switch on brake pedal). left or right turn signal blowing the fuse will tell which side has the short. 4 ways only, replace the relay.

May 21, 2015 | 2004 Jeep Grand Cherokee

1 Answer

Brack lights wont light up on my 1988 ford ranger we keep blowing fuse and put in new brake switch


If you keep blowing the brake fuse than you have a short in the system. Unplug the brake switch. Install a new fuse. If it did not blow than the problem is after the brake switch. Next unplug the turn signal switch, then plug the stop light switch back in and press the brake pedal. Did the fuse blow. If not than the wiring is good in between the two switches. With the turn signal switch disconnected use a jumper wire in between the light green wire (power from the brake switch) and the orange with light blue wire (power to the right brake lamp). If the fuse blows than there is a short in the right side brake circuit between the plug in and the rear socket assembly. If the fuse does not blow than jump from the light green wire to the Light green with orange wire (power to the left brake lamp). If the fuse blows than the problem is in the left hand brake wiring circuit.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Sep 04, 2013 | Cars & Trucks

2 Answers

Tail lights work fine but no brake lights. Fuse keeps blowing whenever I replace the fuse.


check wiring on shift columb going to turn signal switch it could be the switch it self I had this happen on a new chevy truck hope this helps good luck jerry

Feb 16, 2013 | 2001 Jeep Grand Cherokee

1 Answer

2000 Ford Excursion v10. Brake Lights and Turn Signals constantly blows fuse (20 amp fuse) when Brakes are applied. Any reply would be appreciated. Any suggestion of steps on how to narrow down the...


dead sort in system wires to rear also check trailer bug in at rear bad for corrosion
there is a spliter jointer at the rear that splits power to both tail lights

Apr 08, 2011 | 2000 Ford Excursion

2 Answers

All turn signals on my jeep cheroke laredo are not working. Is the problem a bad fuse??


COULD BE BLOW FUSE.FAULTY TURN SIGNAL SWITCH OR FAULTY TURN SIGNAL FLASHERS WHICH IS LOCATED FUSE / RELAY BOX JUST LEFT OF THE STEERING COLUMN.

Dec 05, 2010 | 2003 Jeep Grand Cherokee

1 Answer

My 2005 buick rendezvous keeps blowing the fuse for the turn signals and brake lights. Fuse #42 in the inside fuse panel. this just started happening two days ago. Nothing is different with the car.


most likely caused by a short, could be any were. start with the light assembleys remove it and clean any rusty or coroded spotspull all bulbs clean and or replace .auto parts stores sell an electrical parts wash about 9 to 14 $ . spray as needed let dry and put back together.if it still blows fuses its some ware in the wire s , could also be at the turn signal switch or the brake switch . you would have to get it to blow to figure out witch one it is and witch one it is not example put in new fuse then keep putting on the brakes if not blown then keep doin the turn signal then check to see if blown

Jul 26, 2010 | Buick Rendezvous Cars & Trucks

2 Answers

I have a 1996 Suburban that keeps blowing fuses on break lights


Check the turn signal flasher,and the trailer wire adapter that plugs in under the rear of the truck.Check the brake light switch,to see if it is grounding out on something.

Jan 03, 2010 | 1996 GMC Suburban

3 Answers

Brake lights not working even though the brake peddle is pushed down The switch still goes in and out. Fuse box has some fuses missing. The fuse box does not have a desription on every plug of what it is...


Here are the numbers on your fuseblock and fuses coresponding to the number that is on your fuse block.
1-20 amp (yellow)
Hazard flasher
2-10 amp (red)
back up lights, A/C clutch cycling Switch
3-30 amp (green)
Power windows
4-30 amp (yellow)
A/C or heater blower motor
5-20 amp (yellow)
Panel Lights, Side marker lights, Park, Taillights, Clock & radio display Intensity, License & panel lights.
#6-10 amp (red)
Stoplight, buzzers, Anti-lock brake module
#7-15 amp (lt. Blue)
Tachometer, horn & Relay
#8-8 amp (yellow)
Power Door locks
#9-10 amp (red)
Radio
#10-10 amp (red)
Rear Wheel Anti-lock module, Turn Signals
#11-20 amp (Yellow)
Windshield wiper & washers
#12-15 amp ( LT. Blue)
Cigarette Lighter
#13-5 amp (tan)
Speed Control, warning buzzers, gauges, indicator lights
#14-5 amp (tan)
Time/delay relay & under-hood light, dome light, power mirrors, readio & clock Memory, Interior lights, reading lights
#15-blank
Not used
#16-4 amp (pink)
Radio Lights & overdrive switch light 1989-91, Cluster lights, Cigarette Lighter light & as tray light, Cluster lights, A/C & heater controls.
#17-relay
Hazard Flasher warning
#18-relay
Relay
#19-Circuit breaker
#20-relay
Turn signal Flasher
#21-buzzer
Warning
#22-Relay
Horn

Aug 04, 2009 | 1991 Dodge Dakota

1 Answer

Inoperative tail lights and instrument panel lights


hi may i suggest you check the rear bulbs? as they may be the reason keep blowing fuses probably a short circuit from bulb to earth ?

Nov 18, 2008 | 1992 Honda Accord

Not finding what you are looking for?
2006 Ford F-150 Logo

1,023 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

gerry bissi

Level 3 Expert

4388 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...