2003 Jeep Gand Limited. Blower fan not working. Seems like there is a issue in the area on the passenger side looking from the foot area up there is 3 wires going into a connector that seem to be faulty. If I move around I can sometimes get the blower to work. What is need to fix this?

From autozone.com
Odyssey 2007-2008

Removal & Installation

Print
The blower motor is located in the front passenger-s right side foot well area.

1. If additional access is needed, remove the front passenger-s right side lower kick panel.
2. Detach the electrical connectors from the blower motor.
3. Remove the fasteners on the blower motor mounting flange.
4. Remove the blower motor downward from the blower unit.

To install:

1. Installation is the reverse of the removal procedure.

Your fuse for the blower fan blew, The fan control is bad or the blower fan itself is bad. The fan is located under the passengers side foot area.

on the passenger side. Chances are if you are having problems with the fan not working. The issue will be the harness and the relay connection. All located on the passenger side of the vehicle Note where passengers right foot would, pointing up in that direction is where all your trouble is. Hope this helps..

Clean the blower resistor connector and retest.

Sample pictures here

In passengers compartment. passengers front seat. under side of dash near foot area. lay floor on back look up . If you have a cover pannal under dash board foot area you will need to remove it. the Blower motor resistor is attached by 2 screws and has a flat electrical plug with 5 wires. to the drivers side of Blower motor.

sounds like it could be the motor ..if so nasty job .. you can download complete manuals on the internet for free ..then you can take it from there wether or not you wish to tackle the job yourself .. good luck

Sounds like the blower motor resistor is shot. it's located under the dash on the passenger side behind the blower motor.

In here you can find the location of the Fuse Box, Power Center Distribution and other parts about the electrical system: ZJ-Secc-8W-Wiring-Diagrams (Module & Componentes Location / Page 10, Fig. 16)

I hope help you with this, good luck (rated this help).

Does the fan run on high and no other speeds? If so then it needs a new "blower motor resistor". It is held in by 2 screws behind the glove box. You can see it from the passenger floor looking up at the bottom of the heater box assembly about where the passengers left foot would normally be. If it doesn't run at all it may be a fuse, relay, or the fan motor itself.

Not usually too difficult, but once you locate it, you'll see. Some are under hood at firewall on passenger side area, and some are right on the housing under dash on passenger side, usually close to blower motor connection.