- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
1st you need to open door, remove plastic trim on inside of door by the handle, there is a hole where a 25 torx screw is holding handle end cap, pull door handle in open position, slacken screw until end cap is loose, remove end cap & slide door handle to rear of door out comes the handle, check with torch for any broken parts
look for plastic plugs on the lower part of the armrest, these plugs cover the screws that hold it onto the door panel, use a small blade screwdriver and lever the plugs out and remove the screws.
also look for any screws that maybe holding the inside door handle and remove them.
once all the screws, door handle and the armrest is removed use a flat blade or a screwdriver and lever the door panel off from around the perimeter of the panel
there may be a little bit more than what I have written but what I have told you should get you best part of, if not all the way through this job
ok easy to fix. remove door panel. when u have the replacement parts. start with the outside handle, remove the bolts, undo the bar, remove the handle. same with the inside handles
lift up the door handle and look on the bottom side of the handle, you should see a small black retainer on one side, use something small to push in the canter and a small flat bladed screwdriver to remove retainer. then slide the handle to the front or to the rear to remove.
×