Power rear door on Venza will not open when clicked. It beeps twice. Same when power button is pushed.

latch failure -debris stuck in latch -need to remove panel and examine and test the latch unit

In the Owner's Manual on page 56 it discusses the Back Door. Review that for info. What button are you pushing - inside the car or the remote keyless fob? Does it UNLOCK w/the keyless fob?

Visit the on-line store, know as reliable-store, they have the repair manuals. I'm sure you will get the solution of your problem.
Best Manuals

if it clicks when pushing button the lock is disengaging try providing a little pressure on door and have someone push the button it will probably spring open. the struts might not have enough power to pop it open

There is an off switch on the left side dash. This could be it. Make sure it is not pressed in. If it is ok. Remove switch and check power at this switch.

Thanks! This worked!

Open the rear hatch, look there along the door seal for a cap.

No easy way to do this - you need to remove the inside door panel from inside the truck and manually release the lock. You didn't say where the wiring was burnt, but when the door is open test for power at the lock solenoid - if not there when unlock is pressed, inspect the wiring (particularly at the two rubber wire casings connecting the door to the frame). If it is there, the lock solenoid is stuck and may have to be replaced.

I had almost the identical problem on my 2005 F150 FX4 Extended cab last weekend. The power door locks would not lock using the keypad, remotes, or door buttons. Almost all other functions worked correctly. The doors unlocked, the radio delay functioned, and the interior lights dimmed. When I used the remote the horn would beep twice indicating that a door was open even there was no message on the message center that a door was open. When I used the keypad or remote, I could hear a soft click from behind the seat. I think it was coming from the body security module or body security module - whatever Ford is calling it this year. I pulled the fuse for the Power Door Locks(BSM). As I removed it, I heard a soft click - sort of like a relay resetting. It may have come from the VSM/BSM. It may have possibly been a stuck actuator releasing. I don't think so. It wasn't that load. In any case, everything is functioning correctly now.

Tracy