NOTE: Make sure the correct (second) notch in the pulley is indexed to the lower cylinder block (6010).
Position the crankshaft (6303) just prior to top dead center. Install the Camshaft Alignment Timing Tool on the back of the camshafts.
Position the crankshaft (6303) just prior to top dead center.
2.Remove the bolt and install the top dead center timing peg
3 Rotate the crankshaft clockwise against the peg.I need the timing marks for a 1999 ford escort ZX2 - 5332a96.gifmg src="/uploads/images/5332a96.gif" alt="5332a96.gif" class="h_mi" />
NOTE: Installation of the alignment tool into the exhaust camshaft (6250) may require the camshaft to be rotated clockwise.
Install theI need the timing marks for a 1999 ford escort ZX2 - 9e76853.giflignment Timing Tool on the back of the camshafts.
I need the timing marks for a 1999 ford escort ZX2 - a1cb4c6.gifh_mi">Loosely install the timing chain tensioner.
Using a 6 mm Allen wrench, adjust the timing belt tensioner until the index marks are aligned. Tighten the bolt
Tighten the bolt on the intake camshaft sprocket.
Tighten the bolt on the exhaust camshaft sprocket in three steps.
Install the VCT oil plug.
Position the crankshaft just prior to top dead center.
Install the Camshaft Alignment Timing Tool on the back of the camshafts.
SOURCE: timing belt diagram for 2001 ford escort zx2 dohc
cam shaft timing marks on back of cams ,two slots ,use a flat piece of metal to align .remove no1 spark plug and drop long thin screwdriver down it to bring piston just below tdc,then align cams so both cams are on the rock (valves closed) with knob on back cam aligning with pick up sensor left side between lobes.then bring piston up to tdc and fit belt.turn engine over twice with socket on bottom pulley to make sure no valves clear pistons.Remember to remove flat edge from back of cams i didnt last time and bent my home made tool
SOURCE: where can i find the timing marks on 1998 ford escort zx2 ?
Hello pamgolmon: My name is Roger and i will answer your question. The 2-0 dual cam engine is a interference engine. This means if the engine jumps time at the timing belt. It will bend the valves. As for the timing marks on the camshafts. Their are no marks to be located. To set the timing marks on this engine requires special tools. This makes it expensive for not only the do it yourself mechanic but also the repair shops also. If the valves were bent you must pull the head for the repairs also.
I know this is not the answer you were hoping for but it is the only answer to give. Please rate the quality of the answer as this way we know your answer was correct. Please just ask if you need further help. Thank You for using Fix Ya. Roger
11,081 views
Usually answered in minutes!
×