Cyl head torque on 05 3.4l chev equinox - 1999 Chevrolet Lumina

usa/canada

https://eautorepair.net/Marketing/Default.asp

read it.

It's supposed to do that.

Coolant level full? Rad fan operational? Possible defective thermostat. Worse case plugged rad or head gasket

It should be near the thermostat in the front or on the back of the intake near the edge of the cyl head.

http://www.torkspec.com/torkspecme.aspx?KI=12-4.3L-262ci-V6 Try this link out. It has various torque specs listed for the 4.3. Be sure to check the years to ensure it is the proper torque spec for your vehicle. Also this may not have all the torque specs you asked for, but I believe it has most of them.

its easier to remove the lot ,then you cannot damage the torque converter drive on re-assembly

CHECK WHEEL SPEED SENSOR CONNECTION.IF ALL IS GOOD.PROBLEM COULD BE FAULTY WHEEL SPEED SENSOR.

the big one tighten with a big bar and pull it to about 120lbs ,the three smaller ones which i cannot place at the moment but if they are 17mm size heads then about 60 but i always feel them as i do them and never use a torque wrench or a air wrench ,just muscle and 40yrs of feel

Cylinder Head Bolts

Step 1
Head Bolts A 46 (62)
Head Bolts B 43 (58)

Step 2 Additional 90 Degrees

Tightening Sequence:
http://www.anubiscycle.com/fixya/99cavheadsquence.png

18 lb ft+60°+60°+60°+10°

NEW HEAD BOLTS ARE REQUIRED WHEN REPLACING THE HEAD OR HEAD GASKET.