I need torque specs to change a water pump for a 1999 chrysler cirrus 2.4 liter engine. water pump torque specs.

The pump is part of the timing components. You only want to do this one time. So replace all the timing components. You don't have to replace the crank or cam gears.

Replacing Chrysler 2.2 and 2.5 liter engine timing belts

www.allpar.com/fix/timing-belt-22.html
Replacing the timing belts on Chrysler and Dodge 2.2 and 2.5 liter ... Then loosen the bolts on the crankshaft pulley and the water pump pulley so they will be ...

HOW TO PUT WATER PUMP ON - 1997 Chrysler Cirrus

repairpal.com > Questions > Chrysler > Cirrus > 1997 Chrysler Cirrus
Jul 4, 2010 - WATER PUMP WANT HOLD WATER LONG AND NOW IS MAKING A ...If you change the water pump,you need to also change the timing belt ...

Timing belt - 1995 Chrysler Cirrus - RepairPal

https://www.youtube.com/watch?v=uVg4cQdcn80

http://www.autozone.com/autozone/repairguides/Breeze-Cirrus-Sebring-Convertible-and-Sedan-Stratus-Sedan-1999-2005/Specifications/Torque-Specifications/_/P-0996b43f802d6ed2

it could also be the water pump not pumping water thru the engine i have seen that myself alot

Hi, assuming you have the 2.5 liter engine, your damper is integral to the pulley assembly as shown in the second figure below, so there is only one part involved. You can see an example of the part here: http://www.autozone.com/autozone/parts/Dorman-Harmonic-Balancer/1999-Chrysler-Cirrus/_/N-jddk1Z93y2h?counter=0&itemIdentifier=917091_0_0_
If you look carefully at the pic below, you can see the rubber torus inside the pulley. The rubber is what fails and causes the pulley to wobble. You may need to borrow a puller to get the pulley off.

2.5L Engine

1. Before servicing the vehicle, refer to the Precautions section.
2. Disconnect battery negative cable from remote negative terminal on shock tower and properly isolate to prevent accidental reconnection.
3. Remove or disconnect the following:
   
   Belt splash shield Accessory drive belts. Refer to Belts. Crankshaft center bolt and remove crankshaft damper.
   
   
   

   Fig. Splash shield removal-2.5L engine
   
   
   
   

   Fig. Crank damper and bolt- 2.5L engine
   

To install:

1. Clean crankshaft snout and crankshaft damper bore.
2. Install or connect the following:
   
   Crankshaft damper. Crankshaft bolt and torque to 143 ft. lbs. (182 Nm) Accessory drive belts. Refer to Belts. Belt splash shield

iv never torqued water pump ive always snugged them up pretty good i mean you don't have to stand on the end of the wrench if you use lock tight on the bolts once you tighten them up they wont come loose and you only need a drop of lock tight on each bolt hope this helps you bob

most likley place is on the engine block look for it there

remove the harmonic ballancer

45 Ft-lbs Tie-rod balljoint stud-to-steering knuckle nut, and 55 Ft-lbs Tie-rod (outer)- to- inner jam lock nut

FUEL FILTER IS PLUGGED UP