For no apparent reason, the car alarm on my 2007 Chevrolet Silverado Classic goes off randomly for about 30 - 45 seconds and then shuts itself off. Keyless entry only; no remote start.
SOURCE: programing keyless entry
If you have an owners manual the programming instructions are in there. If no manual here they are:
1. Turn the ignition off.
2. Ground the receiver program terminal. Jump the two terminals located in the programing ground connector. (What this means in simple terms is locate the wires that run on the right side of the trunk. There is two black wires that has a plug on the end with two prongs. It is in between the antenna and tail lights.)
3. Within 2 seconds of connecting the prongs the door locks will lock. The unlock and the rear compartment lid release will produce a cycle, causing the horn to chirp. This indicates that the module is ready for reprogramming.
4. Press and hold the lock and unlock buttons at the same time until the doors lock and unlock. The rear compartment lid will release and the horn sounds to indicate that the transmitter has successfully been reprogrammed. (Hold buttons down for approximately 12 seconds)
5. Repeat the previous step for the remaining transmitters.
6. Remove the jumper at the program connector.
7. Verify the proper operation of each transmitter
SOURCE: Horn alarm randomly beeps
Make sure to check all doors, the trunk latch, and the hood to ensure that they are shut. I have looked up your 2006 Chevy Malibu and there has been a lot of people complaining about the alarm system and it going off. There is a TBS (Technical Service Bulletin) out for your car. The TBS says that the Faulty Door Sensor. Take it to your local dealership and tell him what I found for you and they should get you a quote on how much it would cost to repair it.
Thank you for using Fix Ya!
Good Luck!
Any questions don't hesitate to ask me.
Don't forget to rate the overall satisfaction of this solution.
SOURCE: remote keyless entry not working
KEY FOBS FOR THIS MODEL MUST BE PROGRAMED USING A TECH 2 SCAN TOOL SO IT MUST BE DONE AT THE DEALERSHIP FOR ABOUT HALF HOUR LABOR HOPE THIS HELPS
SOURCE: Keyless entry won't work, only drivers side works electronically
Look for a door lock relay in the fuse panal alot of them are the same swap them around with the door lock one to see if it is bad
415 views
Usually answered in minutes!
It could be any of the door locks (latches) the door ajar switch is made into the lock asbly.I have found that these short out and can cause this. The trick is finding out which one it is. Is this factory or aftermarket keyless entry?
×