Replace windshield washer resevoir on a 2000 ford windstar

Question edited for clarity.
Question moved to category.

The thing that leaps off your question is that windshield *wipers* don't have hoses. It is an electric motor and two articulated arms.

For replacing *washer* hoses, you just buy a length of hose and cut it, or you can buy ready made with nozzles.

https://www.google.com/search?q=2002+Ford+Windstar%2C+windshield+washer+hose

2002 Ford Windstar Accessories, Body & Wipers Parts

https://shop.advanceautoparts.com > ... > 2002
Find low prices on 2002 Ford Windstar aftermarket and OEM Accessories, Body & Wipers parts & products. Buy online, or pickup parts at any local Advance Auto ...

for better result download the pdf file
Ford Windstar 1999 to 2003 Factory Service repair manual

Replace the washer pump

Get it at a dealers parts dept

Make sure your washer fluid line that goes from the tank to the pump is connected.

the pump is in the bottom of the washer fluid tank.

the pump is in the washer fluid tank, they are replaceable

this might be a connection/ currosing problem. Check the windshild wiper relay for loose wires and then take apart the connection. Clean them up and put back together. also check your fuses.

If you here the pump working check the hose to windshield to see it was pinched when closins the hood .I fixed mine wih black electrical tape and it works fine for now.

Reservoir —Windshield Wiper

Removal

1. Remove the RH wheel; refer to Section 204-04 .

1. Position RH splash shield aside.
   1. Remove six screws.
   1. Remove three pin-type retainers.
   1. Position RH splash shield aside.

1. NOTE: Windshield washer fluid should be collected in a container after the windshield washer hoses are disconnected.
   Disconnect the electrical connector and washer hoses.

1. Remove the upper reservoir bolt.

1. Remove the windshield washer reservoir.
   • Loosen the two lower reservoir bolts.

------------------------------------------------------------------------------------

o2 cencers will cause stalling if your engine light is on get it scanned it will tell you if it needs to be changed