-
Ford Master
2,993 Answers
- Posted on Nov 13, 2009
Re: Where is the map sensor located and how do I install...
-
Disconnect the negative battery cable.
-
Remove the air cleaner outlet tube by loosening the retaining clamps, then tag and disconnect any hoses or tubes.
-
Disengage the engine control sensor wiring connector from the mass air flow sensor.
-
Remove the four retaining bolts, then carefully remove the sensor from the vehicle.
-
Discard the mass air flow gasket.
To install:
-
Position the mass air flow sensor with a new gasket onto the air cleaner cover.
-
Install the four retaining bolts, then tighten them to 25 inch lbs. (3 Nm).
-
Install the air cleaner outlet tube by aligning the white identification mark on the tube with the tube stop on the throttle body, then tighten the retaining clamps to 24-48 inch lbs. (2.7-5.4 Nm).
-
Engage the engine control sensor wiring connector to the mass air flow sensor.
-
Connect the negative battery cable, then start the engine and check for vacuum leaks.
×