Cruise control problems - Civic Honda Cars & Trucks

Which engine ?
Cruise Control Description and Operation (3.6L)
Cruise Control Description and Operation (3.4L)

Do you know what all is involved in C.C. operation ?


Cruise control is a speed control system that maintains a desired vehicle speed under normal driving conditions at speeds above 40km/h (25 mph). However, steep grades may cause variations in the selected speeds. The main components of the cruise control system are:
• The cruise control module assembly
• The cruise control switches
• The cruise control release switch
• The powertrain control module (PCM)
• The stoplamp switch assembly
• The vehicle speed sensor


The cruise control module controls the operation of the cruise control system. The cruise control module monitors the signal circuits of the cruise control switches. When the normally open cruise On/Off switch closes with a switch activation, the cruise control modules detects a high voltage on the signal circuit. The cruise control module activates the cruise control system.The set/coast switch and the resume/accel switch will not operate the system when the cruise control module has not activated the system based on the cruise control on/off switch signal circuit .
The cruise control module monitors the cruise control set/coast switch in order to determine when to capture and maintain the vehicle speed. The cruise control module monitors the vehicle speed signal circuit in order to determine the desired speed. The PCM pulses the vehicle speed signal circuit at 4000 pulses per minute. After an initial set speed has been established, the cruise control module also uses the cruise control set/coast switch signal circuit in order to tap down the set speed when the cruise control module detects a switch activation.
The cruise control module monitors the cruise control resume/accel switch signal circuit in order to determine when to resume the previous set speed. This feature only works within the same ignition cycle and as long as the cruise wasn't turned off using the cruise control On/Off switch since the last cruise engagement. After the set speed has been resumed, the cruise control module also uses the cruise control resume/accel switch signal circuit in order to tap up the set speed when the cruise control module detects a switch activation.
The cruise control module assembly has a controller and an electric stepper motor to vary the throttle in each different cruise control mode. Two components in the module assembly help to do this. The electronic controller and the electric stepper motor. The controller monitors vehicle speed and operates the stepper motor. The stepper motor operates in response to the controller, to maintain the desired cruise speed. The electric stepper motor moves a strap that is attached to the cruise control cable which moves the throttle

Cruise Control Problem - Nissan Forum

www.nissanforums.com/b13-91.../135028-cruise-control-problem.html
Jun 21, 2007 - 4 posts - ‎3 authors 1994 Nissan Sentra 4Door XE with 5 Speed Manual, GA16DE, 230k Miles. ... Now theCruise control light in the middle of the dash will NOT light up and the cruise control will not engage no matter what button I push. .... Cruise Control NOT working.. sentravis, B14 95-99 chassis, 26, May 29th, 2009 12:24 ... speedometer not working?
15 posts
Aug 3, 2007
Solution for P0500 VSS speed sensor problem on Nissan ...
15 posts
Jul 10, 2007
Solved flashing cruise control light
8 posts
Sep 8, 2006
cruise control problem
11 posts
Jul 13, 2005
More results from www.nissanforums.com

not being informed if it is auto or manual, here are some of the items that control the cruise control
brake pedal sensor ,
clutch pedal sensor,
vehicle speed sensor
engine ignition control module , tacho ,
vehicle speed --will disconnect if the road speed is below setting minimum speed
ratio changing
bad cruise control switch
wiring and connections
ecm problems
problem cruise control module

It can be faulty cruise control switch. If the switch is replaced, then it can be wiring issue or faulty cruise control board. But as the switch is replaced, get the voltage at the switch tested to confirm the switch is actually receiving voltage. If no voltage received at switch power supply wire then, apply external 12 volt power to the cruise control switch wire and then see if cruise control comes ON. If yes, then you know wiring is issue.

On this case, to troubleshoot this problem, there are solved help links. Click the link directly and refer the details to solve this problem yourself, with help of diagrams: ------

CRUISE CONTROL
http://alltypesofpartsreplacing.blogspot.com/2012/12/cruise-control-not-workingcruise.html


----------
These will help.
Thanks.

If the switch is replaced,then it can be wiring issue or faulty cruise control board.But as the switch is replaced,get the voltage at the switch tested to confirm the switch is actually receiving voltage.If no voltage received at switch power supply wire then ,apply external 12 volt power to the cruise control switch wire and then see if cruise control comes ON.If yes,then you know wiring is issue.
=============

On this case, to troubleshoot this problem, there are solved help links. Click the link directly and refer the details to solve this problem yourself, with help of diagrams: ------

Ford ranger cruise control not working? http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html

-----------

Horn and Cruise control quit working?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html

--------

Horn and cruise control not working on Plymouth Grand Voyager?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html

------------------

Horn and Cruise control quit working on 2003 Jaguar S-Type?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html

-------------

Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500

http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------

Cruise control stop working on 1994 Ford ranger?

http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html

----------

Cruise control not working?

http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html

--------------

1996 Ford Explorer: Cruise Control Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/1996-ford-explorer-cruise-control.html

----------

These will help.

Thanks.

On these case,to troubleshoot these problem,there are solved help links.Click the link directly and refer the details to solve these problem yourself,with help of diagrams:------
Ford ranger cruise control not working?

http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html

----------- Horn and Cruise control quit working?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html

--------

Horn and cruise control not working on Plymouth Grand Voyager?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html

------------------
Horn and Cruise control quit working on 2003 Jaguar S-Type? http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html

-------------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
Cruise control stop working on 1994 Ford ranger? http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html

----------
Cruise control not working? http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html

--------------
1996 Ford Explorer: Cruise Control Wiring Diagram?

http://schematicsdiagram.blogspot.in/2012/06/1996-ford-explorer-cruise-control.html
----------
These will help.
Thanks.

To troubleshoot your problem,there are few help links,provided below.Click the link directly and follow the procedure to confirm the fault.So as per that you can continue further in repairing this issue of cruise control not working.
The direct help links are as follows :-----cruise control not working?

http://technoanswers.blogspot.in/2012/02/ford-ranger-cruise-control-not-working.html
-----------Horn and Cruise control quit working?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working.html

--------------
Horn and cruise control not working on car?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-not-working-on.html

------------
Horn and Cruise control quit working suddenly?

http://howtobyme.blogspot.com/2011/11/horn-and-cruise-control-quit-working-on.html

----------

Cruise control stop working ? http://technoanswers.blogspot.in/2012/02/cruise-control-stop-working-on-1994.html

---------

ford ranger cruise control not working? http://technoanswers.blogspot.in/2012/02/2005-ford-ranger-cruise-control-not.html

-------------

My Cruise control not working? http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html

----------

This troubleshooting help links will help you to confirm the problem.

Thanks.

CHECK TO SEE IF BRAKE LIGHT WORKING.BECAUSE BRAKE LIGHT SWITCH DEACTIVATE CRUISE CONTROL WHEN BRAKES APPLIED.MOST TIME IF YOU HAVE CRUISE CONTROL PROBLEMS FAULTY BRAKE LIGHT WILL CAUSE CRUISE CONTROL PROBLEMS.