Hi,
In order to get the radio code, you need to retrieve the serial number from the top of the radio.
To do this, remove the two philips screws below the radio trim panel and remove the trim panel. The serial number is on the top left corner of the radio on a white sticker.
Provide that number to your local dealer parts counter or over the phone and they will decode your radio for you, or add a new question here with that information and I can provide the unlock code for you.
SOURCE: RADIO/CD PLAYER 2002 MITS ECLIPSE GT
You will have to call Mitsubishi for the code if it's not in the Owner's Manual (like my wife's wasn't). Call Mistu with the VIN# and Serial# of the radio at hand.
To get the VIN number, check the bottom of the front window.
For the Serial # from the radio: Remove the two screws under the center console. There is one on each side of the console (you may have to lay on the floorboard to see them clearly). Then pull out the two air vents from the center console (this will help you get a good grip for the next part). Hold the edge of the top of the console and the air vent for either side and pull it towards the rear of the car. I had to wiggle the console pretty vigoursly to get both sides out. Be sure not to pull it too far from the dash right away because you'll need to disconnect the hazard light switch prior to completey removing the console cover. Once that is disconnected you can safely move the console cover. This will expose the mounting braket. There two screws on the side of the mounting braket for the radio. Just unscrew those and you can remove the radio and see the serial number on top of the radio (you may also be able to see it if you just look in the space above the radio while it's still in the mounting braket but I wanted to make sure I had all the numbers/letters correct and didn't have to go through this again). Just do everything in reverse (don't forget to plug the hazard light switch back in!) to get it all back together.
SOURCE: radio code Eclipse Spyder,how do you enter
Contact your local Dealership and ask for Parts. They have all the Codes and can tell you by Running your VIN Number.
SOURCE: need 4 digit radio code for 2001 mitsubishi eclipse
try to call the mitsubishi dealer coz every radio has different code thats the only way you can get those code.
SOURCE: 2001 mitsubsi eclipse enter car radio wrong code 3 times
call 1888mitsu2001, choose option #4, then hit * (star). give the
operator the last 8 numbers in your vin and they will provide the radio
code for FREE!
DO NOT PAY FOR THE CODE ONLINE OR GO TO THE DEALER (they will also charge you).
- you will also need to provide the serial and part number of your radio
(takes about 5 minutes to take apart an eclipse dash...1 screw in the
bottom of the HVAC panel) if you call the 1888mitsu2001 it will provide
basic instructions on how to accomplish this.
- if your radio says "off" (meaning you entered the wrong code too many
times) you need to put your key in the ignition and turn it to ACC mode
for approx. 45min - 1hr and then your radio will say "code" at which
point you can enter the code to unlock the radio.
SOURCE: need radio wiring diagram for 2001 mitsubishi eclipse
CHeck HERE the 2001 diagram.
Hope helps (remember rated this).
214 views
Usually answered in minutes!
×