The signals on my 98 chevy malibu dont work, I need to replace the flasher.Where is the flasher located on the 98 chevy malibu?
Replacement
The turn and hazard flashers are integrated into one flasher on these models. The flasher is located in the hazard warning switch and the hazard warning switch is located on the trim plate. Replace the flasher by unplugging the old one, removing it from the panel, and plugging in the new one.
Remove the bezel from the ignition switch
Carefully remove the instrument panel accessory trim plate.
To remove the trim plate, use a suitable prytool to carefully apply pressWhere does the flasher go on a 98 chevy malibu - bd28884.gifretaining clip points . . .
. . . then gently pull the accessory trim plWhere does the flasher go on a 98 chevy malibu - daa6205.gif />
Detach the electrical connector from the hazard warning switch.
Unplug the electrical coWhere does the flasher go on a 98 chevy malibu - c506713.gifm the hazard warning switch . . .
Unfasten the screw securing the hazard warning switch and remove the switch.
. . . then unfasten the screw securing the hazard warning switch and remove the switch from the vehicle
Installation is the reverse of removal.
Testimonial: "just what I needed, thank you so much."
The flasher is part of the switch that is on the dash.The one you push to turn on the flashers.If this does not take care of your problem then you will have to replace the multifunction switch which is the turn signal switch.But you are on the right track.Try the flasher first because the turn signals go through the flasher.Sometimes if you wiggle the flasher the turn signals will work.Good luck.
Testimonial: "very good bit of information"
The flasher is part of the hazard flasher and is located in the center dash behind the hazard flasher button.
2,904 views
Usually answered in minutes!
×