VTM4 LIGHT ON after gear was changed, but car drives smoothly and CHECK NENGINE light does not come on. Have diagnosed and was told nothing wrong with transmission. Please help
I'm not sure I understand the problem, but the indicator light comes on in order to indicate that you Variable Torque Management system (4WD) is locked.
To Disengage the VTM-4 lock, do one of the following:
Press the VTM-4 lock button.
Move the shift lever to D or D3 .
Turn the ignition to LOCK (0).
The VTM-4 lock will temporarily disengage when the vehicle speed exceeds 18 mph (30 km/h). It will automatically engage again as the speed slows below 18 mph. The indicator in the button will remain on.
If the problem is something else, leave a comment and I will investigate further.
I should add that if you have also had a malfunction light (check engine) come on, it is common for the VTM light to come on at the same time or often by itself afterwards. There is (I am told) some connection between the EGR valve and the VTM in regard to the vehicle's computer so the lights may both go on. You might want to have someone with an OBDII code reader see if the Pilot has any codes stored for reading (especially regarding the EGR Valve). Autozone will do that without charge.
The book that comes with the truck is incorrect,I used your method to turn the system off and it worked,Now the light is off and the truck runs normal.
×
Hi Guys the VTM-4 light on my 2002 mdx is on.
I tried the methods in the manual and is not going off.What to do?
SOURCE: i got check engine light and vtm 4 light on my
its a sensor packed up visit a local mechanic to fit a new sensor
SOURCE: abs and vtm-4 dash lights on. When driving under
Your wheel bearing is the fault.Get it changed ASAP.Good luck hope that was helpfull.
the abs means that your brake pads or shoes are gone or its not connected n the other rest i am not sho
20,063 views
Usually answered in minutes!
indicator light come on
×