1998 dodge ram pickup 318 eng. engine idle rough on warm-up engine idle rough after warm-up shutting off engine and starting back up engine also runs sluggish in over drive at a low idle. I have replaced , plug wires,coil,plugs,distributor cap,rotor,o2sensor, engine runs well over 1500 rpms.
If the engine seems to run fine over 1450 RPM maybe there is a vacuum hose leaking or EGR valve is slightly stuck open. Any help from the OBD II trouble codes? Or is there simply no MIL and no stored information in the OBD II computer read at the local parts store through the connector by the drivers knee?
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
My first car was a 1969 Dodge Coronet station wagon with the 318 cubic inch engine. Loved it!
In my experience, the most common reason for this behavior is a bad crank or cam position sensor (assuming your car has one of those), since they tend to fail hot.
Another possibility is that a dirty or worn ignition switch is supplying power to starter, but not the engine, when it gets warm. Try spraying with WD-40 to see if that helps.
If your engine cranks normally but will not start because it has no spark, or it ... If an engine has a coil-on-plug ignition system with no plug wires, remove one of ...
? 5:13
https://www.youtube.com/watch?v=XSWN1M8Hoqo
May 19, 2010 - Uploaded by FrankHurtAuto
Simulation of no start with no spark diagnosing, ... Ignition coiland module test with test light (ScannerDanner Premium lecture) - Duration: ...
CarGurusJun 12, 2013 - 2000 dodge ram 1500 4x4 not getting fire changed distributor cap, coil, pickup ignition, rotor, plugs, plug wires 2 answers. ... 1994 dodge 5.9 just shut off and wont start back up there is no spark or fire from coil or plugs. ... 94 dodge van 318 eng will not start new plugs new crank ...
CarGurusApr 12, 2011 - dodge dakota idling and dying - My dakota will start then idle down and die. ... I have a 1992 dodge dakota that dies on me at stop signs and when I take my foot off the gas pedal. ... Had the same problem with my 98 Dakota.
CarGurusAug 29, 2011 - 1998 1500 5.2 Shuts Off Randomly - does anyone have an answer to the mysterious shutting ... 1998 1500 5.2 that shuts off randomly and if i wait a few seconds to minutes it will start again. ... does it do it when coming to a stop or when taking off from a stop or shifting from drive to .... Used Dodge Dakota".
I have a 91 dodge dakota truck with a 318 motor, 249,000 miles, it will start up thenshut right off when I take my foot off the gas pedal, I had a tune up a month ...
? 4:05
https://www.youtube.com/watch?v=XRVQEdnei34
Mar 26, 2014 - Uploaded by AoDMADPenny
It would rev up then back down to about 200 rpm then just shut off. ... My Dakota dies during idling right after i start it up and then it wont start back up again. .... 1998 Dodge Durango No Start or No Bus or Randomly Stalls ...
CarGurusGet fast answers to your Dodge Ram 50 Pickup questions from experts in the ... 1986 Dodge Pick Up 5.9 Wont Start I Put New Distributor Set The Timing, New.
CarGurusCarburetor - I recently bought a 1989 2.6L Ram50 for my son. ... Asked by redoverfarm Apr 13, 2010 at 03:36 PM about the 1989 Dodge Ram 50 Pickup ... check your fuel injector...may be clogged dirty, get a fuel injector cleaner or carburator ... Also gets poor gas mileage and is hard to start when the engine is warm !
www.dodgetalk.com > ... > Dodge Ram Truck 1st Gen (88 - 93) Forum
Sep 22, 2011 - Hey guys i got a 1989 Ram 50 and im hoping i can get some help here. She drives like a champ but she only starts when i push start it, once i ...
I have a 1988 dodge ram charger with a 318 motor with throttle body. It runs really good when I start it up and drive it for about a half of an hour. But after that when I step on the throttle a little bit, it hesitates. If I let off a little bit, it will go or if I really step on it, it will go also, but if I just hold it there, it really hesitates If I stop, the idle jumps up and down so much it causes itself to stall. It seems to only do this at low RPM's. If the RPM's are higher it's fine
×