At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
2000 chevy Blazer Emergency brake stuck on. Was able to get them to stop squeeling, by going in reverse, but light is still on. Afraid may have frozen here in Omaha, NE?
Re: 2000 chevy Blazer Emergency brake stuck on. Was
Sounds like a likely possibility, the reverse method definetly did the trick in loosening the brake, but it may still be slightly applied, put it in a warm place when you can, or have a shop look at it indoors, it may need to be re-adjusted, or even just warmed up until the cable frees up again
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Measure the lenth of both rear ends. see iss all hardware will bolt up without fabrication. if its the same size it will work. But im afraid being a 4 wheel drive it will be geared lower then a regular pick up/ Drive shaft may work but if not it would have to be shortened or lenghthebed. alot of work. Brakes you could leave the non drum breaks on better stopping power. I honestly believe you would be better off just going to a scrap yard and find one very easy to remove and replave few hour job.
Have tried taking the parking brake cable loose? Have you tried removing parking brake assembly? Do you have brake drums on the rear? Have you tried drum brake adjust to loosen?
24 posts - 16 authors
Went to release the parking brake on my 04 and the cable snapped. ... More like the end cap coming of the cable that attaches to the foot pedal. ..... Then I released the parking brake, pulled out the broken release cable/handle assembly, ...
? 5:54
https://www.youtube.com/watch?v=qx0oGfV62NQ
Jun 23, 2011 - Uploaded by 1A Auto Parts
How To Install Repair Replace Parking Brake Release CableHandle ... or replace a broken or worn out parking brake release cable handle.
that is strange. for the ABS has its own relay and so does the heater blower motor. they do not share the same outlet , I would check the wire at the bottom of the fuse box
e emergency brake cable has to be removed at the pedal on the kick panel and not at the dash pay attention on removal and repeat steps to reinstall as it can be slid in from the front of the dash for new install but has to be removed in reverse steps
Try starting the vehicle , place the emergency brake on , switch from drive to nuetral. with engine running try to move the 4wd handle. If your handle moves in and out of 4 wheel drive and the selector handle moves into 2wd you need to drive the vehicle to get it out of 4 wheel low otherwise the 4 wheel drive solenoid may be stuck . This is located on the front axle . round with a vacuum line coming off it. Check the vacuum line at the solenoid or it may be the solenoid. Gook luck with your fix
×