What is the size of the allen wrench needed to fit the oil pan drain plug in a 1995 toyota celica

Radiator is on the drivers side in front of the radiator(White). Oil pan is on the back side of the pan in the middle. Not one for the transmission.

-What are you looking for...? You mean Allen Wrench...?


Good Luck


Mai

i dont know how much that is as i am in the uk.
i would check around and call a couple off garages and see how much they would charge you.

You will need a very large allen wrench (like 19mm or so) for the drain and fill plugs.
This is an uncommon size so if you do not want to invest in one just have a shop do it.
If you decide to go ahead, get GL-4 hydraulic oil and a pump. Remove fill plug first (to ensure you can before draining transmission!) on side of transmission, about mid-line.
Then remove drain plug (center bottom toward engine). Have catch pan ready.
Once it has all dripped out, replace drain plug and fill with pump through side plug until it starts to drip back out (car level).
Let it finish dripping out, replace plug and good to go!

Your 1983 Toyota Celica takes 4 quarts with new filter,Since your just adding,it depends what is showing on the dip stick,you say it's real low,which it probaly will take a least a quart,then add that and wait a few minutes to get to oil pan,then check dip stick twice and if still low,open another quart and add a fourth and check,add more if needed,then after you have drove,park,let sit,then check.If you add to much,there's a drain plug at oil pan underneath,You can go to Autozone and buy oil and ask if they will add,they will do it for free.

You only need a few. You need a wrench or socket that fits the oil pan drain plug. Car makers have used all sizes of drain plugs, don't know Saturn's, anywhere from 13 millimeter to 19 millimeter size wrench or socket. One of them will fit yours.
So one wrench (when you find the right one) and you will need a drain pan to catch the oil. Next you will need an oil filter wrench or tool. There are several types and sizes-when you buy the new oil filter you can get the filter remover that fits your filter . A parts person should be able to help you select the right one. Also buy a small funnel to pour new oil into the engine .And don't forget to have a few rags handy to clean up spills and wipe off areas. That's about all that is normally required.

locate oil drain plug on oil pan,engine off. take out oil plug with wrench, drain oil into a big pan or similar. when oil is drained remove oil filter and put new one on, put some new oil on filter seal with finger then screw on to car as tight as you can get it by hand. do not use a fiter wrench to tighten filter only hand tight. use oil filter wrench to take off old oil filter. when filter is on put plug back in oil pan and tighten. then add your new oil to reccomended oil level.

crawl under the car with a drain contaner and a cresent wrench. Under the engine is the oil pan. The drain plug is located on the bottom end or slightly above on the side. It may be covered in dirt so scrap around. It has to be there. No other place for the oil to come out. It is possable it is a plug type with a large allen wrench hole or a squar hole that a ratchet will fit in to but most of them it is a bolt type. Don't forget to change the oil filter when changing oil. Let me know if this helps, The Raz

1. Ramps or jackstands (do not do this with only a jack)
2. Appropriate wrench to fit the drain plug
3. Filter wrench for your filter size (when you buy the filter you can decide which size you need - there are 2 sizes)
4. Drain Pan
5. Oil filter and Appropriate amount of oil (recc - 10W30)
6. Creeper for comfort if you prefer
7. A bundle of rags

crensant wrench sould do it it adj in size