Toyota prado 1996 electric window and mirror on drivers side is not working. Whole drivers door window control panel and also mirror on that side) Is this a fuse? If so where is fuse?

1- Door locks 2- Windows 3- Seat control 4- Drivers side mirror control 5- Drivers side mirror 6- Locks don't work To access these controls you need to use the "code" to unlock them. I cannot remember the code now but try texting me and I'll send the code to you.

Check the switch module for disconnected.

CHECK FUSES FOR POWER WINDOW,CHECK FUSE FOR POWER MIRROR AND CHECK FUSE FOR POWER DOOR LOCK.IF FUSE OKAY DOOR CONTROL MODULE FAULTY ITSELF.

if the parado has automatic windows and they are not working from the driver's seat then wind down windows from each door and then pull them back up and keep the button pulled up for a few secs, this will reset the controls and the windows would start working from Drivers door, this has to be repeated number of time for each door

anywhere from the switch to the motor inside the door can be the problem. you need to take off the door panel and test the motor

This should help you out for now. Also the BGB is there for future reference. www.mr2-tech.com/bgb/mechanical/volume2/body_electrical_system/Manual_1325_0001.jpg Good luck!
If you find its not the relay and its a motor let me know....keep me posted.

Its "doable" but I wouldn't advise you to do it that way. Get a phillips screwdriver to unscrew the elbow pad & any other screws holding the door panel on. Disconnect the pwr window switches & any other switches on the panel. On the lower end of the door panel there are plastic clips holding the panel to the door. POP them out of the door & remove the panel. disconnect the mirror electrical connector & disconnect the mirror body itself. Install the new one & don't forget to connect all of the electrical connectors & reinstall the panel. Good luck

Yes, you have to remove the door panel.

Remove the 2 plastic protectors on the front edge, and remove the 2 brass colored screws. Next, remove the push pins from the latch side. Push in, and pull out the whole thing. Next, under the armrest, remove the screw. Lift up the power windoe control, being careful to not break the plastic retainer tab. Remove the screw under the window control. Starting at the bottom, pull out the panel, and, when all of the clips are loose, pull the panel straight up. It is best to do this with the door panel as warm as possible, like in a heated garage. Doing this outside in the cold will break all of the plastic retainer clips; they are quite brittle whn cold.

I hope this helps

Thanks for choosing FIxYa for assistance. A FIxYa rating (4 blue diamonds) would be greatly appreciated.

Yes that whole plate needs to come off. Be careful as some of those torx heads are just for show and not actual screws. The door handle also needs to be removed. There are three screws for the handle, usually a torx head. The door panel will then unclip and with the window down you can push in and pull up gently on the upper door trim (hard plastic part) to release the door panel from the door.

On the inside trim, you can remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them. You'll need to lift the door panel upwards in order to get it off the window ledge. Then you'll need to manipulate the panel and disconnect the door handle linkage from the door handle and disconnect the wiring for your controls. Then you can access the bolts that secure the mirror onto the door