by JohnnyMember since:July 03, 2006Total points:2,930 (Level 4)
- Best answer 23%
- 566 answers
Member Since: July 03, 2006Total Points: 2,930 (Level 4)Points earned this week: 0
Best Answer - Chosen by VotersFollow the
fuel line from the
fuel tank towards the engine till you see a soda can sized canister , it should have a metal strap around it holding it to the frame. The lines are under pressure so run the truck then pull the fuel pump fuse while its still running. Use line wrenches so you don't round down the fittings on the fuel lines. Some gas will drip out so do this in a well ventilated area. Its not hard to change but it might be hard to get off, spray some penetrating oil( PB Blaster) on it to dissolve any rust around the fittings. Install the new
fuel filter ( arrow pionting towards the engine), replace the fuel pump fuse and start it up and check for leaks.
what is your question
×