The one above is for :
Accessory serpentine belt routing—2004–05 5.9L Diesel engines without A/C
The one below is for:
Accessory serpentine belt routing—2004–05 5.9L Diesel engines with A/C
Please do not hesitate to ask any further questions about your vehicle. Also please do not forget to rate and comment about your experience with fixya today.
Usually there is a belt routing diagram located either under your hood, the support rad or onto one of the inner fender.
I do not have a diagram to send you but hereafter is the probable routing. It belongs to you to validate if it makes sense. At least it should give you some hints about reinstallation.
First check/make sure that you have the right replacement part comparing to the old one.
Routing:
- over the idler pulley located at the center top
- going to your right over the power steering pump
- going to the center over the radiator fan pulley
- going down over the crankshaft pulley
- next one should be your automatic belt tensionner (may a good idea to finish there)
- going lower left over your A/C compressor pulley (assuming A/C equipped)
- next one go over your alternator pulley
- next over the water pump pulley
- you're back no the begenning point idler pulley.
Obviously threaded side of the serpentine must sit on threaded faced pulley and flat side of the serpentine must sit on flat faced pulley. Otherwise, my routing is not right or you made a mistake somewhere.
I hope that I'm right and that it will help
Dan
There should be a belt diagram sticker some where under the hood.
936 views
Usually answered in minutes!
×