Usally tearing belts is the ac compressor not turning or poorly. your tension could be going bad also alllowing the belt to flex and contact another object. you will need to block your wheels.open the hood. have a freind rev the engine in cycles for you to watch and see if the belt flexes or the ac commperssor is the cause
Waterpump pulley loose or warped.
One of the nex parts not turning freely/ac,alternator,steering pump or tentioner. make sure to chek them all.
SOURCE: how do you adjust the tension on 1995 cadillac
usually these are self tightening held with tension with a automatic tensioner if your car dosent have an auto tensioner then look for an adjustment screw turn it clockwise until the desired tension is accuired. there may be a locking screw behind the adjuster if so loosen that and then make your adjustments.
SOURCE: replacement sequence for serpentine belt for a 96 cadillac devill
Assuming you have the Northstar engine
SOURCE: 1995 cadillac deville how to
You'll need to locate the tensioner pulley and rotate it toward the center of the engine with either a 3/8 or 1/2 inch ratchet or breaker bar. This will allow you to pull the old belt off and install the new one. There should be a sticker near the radiator that shows the belt routing, if not there will also be a diagram in the owner's manual. This is a fairly easy job so good luck.
337 views
Usually answered in minutes!
×