SOURCE: inatallation 92 honda accord power steering pump
Hey, here's the procedure, disable air bag, if equipped w/ one, disconnect the pump return hose from the reservoir and place the end in a large container. Plug the port in the reservoir. Start the engine and turn the steering wheel lock to lock several times, until fluid stops running from the hose. Turn off engine immediately. Re-attach hose. Disconnect the inlet and outlet hoses at the pump. Remove the drive belt. Remove the mounting bolts/nuts and remove pump.
Install in reverse order. Adjust belt tension,fill ps reservoir and bleed any air from the system (to bleed air from system, fill reservoir, start engine and allow to idle, turn wheel from side to side all the way several times. Shut off, fill if necessary.
. Tighten bolts to : Thru bolt 30 ft lbs., mounting nut 16 ft lbs.
SOURCE: service for 2006 honda accord
Usually Honda Accord needs services in 30, 60, 90K.
Regular Oil change in every 5000 miles.
An easy way to see is sign up for Honda's Ownerlink.
https://www.ahm-ownerlink.com/
All you need is your VIN number (usually found on the door jam, outside bottom of the windshield, trunk, etc)
Once you got your car registered, go to the service/maintainece linkand then click "View your factory-recommended Maintenance Schedule."and its all in there
Hope that helps!
SOURCE: 2002 Honda Accord EX V6 cruise control failure
http://www.handa-accessories.com/accord/accswc.jpg
So after you push the button and then press the set button in the steering wheel it does not get into cruise control ? It sounds like a minor electrical problem. If you have warranty still I think the dealership should fix it for free.
Sorry i have not been able to help you.
SOURCE: 2006 honda accord rear defrost cuts out radio
sounds like bad connection on glass grid causing interference noise to radio.. does the rear defrost work ok ???
SOURCE: How do I enter the code for my 2006 Honda Accord
Use the preset buttons to enter the five-digit code (I assume that you have that; if not, see below). When it is entered correctly, the radio will start playing.
If your vehicle is equipped with a navigation system, press and release the TUNE knob; the number ‘‘0’’ appears on the display.
If ‘‘0’’ is the first digit in your code, press and release the TUNE knob to store it.
If ‘‘0’’ is not the first digit in your code, turn the TUNE knob left or right until the first digit is displayed.
Press and release the TUNE knob to store it. Enter the remaining digits the same way.
If you make a mistake entering the code, do not start over; complete the five-digit sequence, then enter the correct code. You have 10 tries to enter the correct code. If you are unsuccessful in 10 attempts, you must then leave the system on for 1 hour before trying again.
If you don’t have the code, a dealer can access your code with your radio’s serial number. To access the serial number, turn the radio on. It must display ‘‘CODE’’, then turn the radio off. Push the preset 1, preset 6, and power buttons at the same time, then quickly release.
Hope this helps you.
Testimonial: "This was very helpful. I was having difficulty with what I should do when I saw the letters come on the screen spelling code while I was inputting it."
328 views
Usually answered in minutes!
I'm having the same issue with my radio. I'd really like to get a solution for this
×