Where Is The Camshaft Position Sensor Located On A 1999 Isuzu Rodeo?
For the four cylinder it is located
in the front part of the engine. you have to remove the spark plug
cover cap, then remove the serpentine belt. remove the timing belt
cover, then remove the timing belt cover mounting screw located in between the two gears.
For the 6 cylinder it is on the back of the drivers side head just
behind the intake manifold screwed in from the outside 10mm bolt.
SOURCE: Crank Sensor in 94 Isuzu Rodeo
it's on the bottom of the motor, towards the back on the passenger side. It has a small clip of wires and one screw holding it on. You may want to pull it up on ramps- if it'll run- otherwise, get under the Rodeo, it's up a little higher than the oil pan, and to the passenger side. (it's right on top of the two lines that run to the bottom of the radiator.) You will need a 10mm socket to remove it. I have added a few pics showing the location (i just completed this task myself)
SOURCE: 1999 Rodeo,, Isuzu, starter motor and solenoid
Follow positive wire to starter that has the solenid on it.
4,752 views
Usually answered in minutes!
×