2005 dodge caravan . Brake lights work normally when ignition is off. When ignition is on and you push on the brake pedal and release the brake lights stay on. i have replaced the brake light switch under the dash and its the same. Turn signals and flashers work fine.
SOURCE: dodge caravan sliding doors
First, keep in mind that as you begin to remove these doors you run the risk of causing serious scratches to the paint and glass, so put some masking tape and/or plastic sheeting around both sides of the door (rear quarter panel and rear glass, front door and front door glass)
I would get a Haynes repair guide since that's what I have to work from and it will tell you step by step with pictures, what to do. It's not hard, but you need to get all of the attach points unhooked to be successful. Suggest you have a helper working with you to keep the door steady.
SOURCE: Airbag dash light
You can reset the light by disconnecting the battery fro 15 minutes and then reconnecting it. If the light comes back on you will have to go to the dealer for a fix. A general scanner will give you a code with a generic description of the problem but to have it fixed right you need to unfortunately bring it in.
Please remember to rate this solution.
SOURCE: the brake lights wont work on my 2001 dodge caravan
Sound like the brake light switch is gone. this part is attached to the brake pedal.
SOURCE: Dodge 2005 Grand Caravan water Pump replacement
how difficult is it to change a water pump on a 2005 caravan 3.3L?
SOURCE: 1997 Dodge Caravan No Brake Lights
i have the same problem you have to put a bit of solder on all the tips of the connectors were the bulb goes in and it will be fixed
1,020 views
Usually answered in minutes!
×