Its a 94 honda accord and they have a sealed no pan type of transmission. It almost looks like a manual transmission. How do you repair the leak in between the transmission where it bolts together. This leak is not at the engine where it bolts to it. Its at the center of the tranny.
First clean off the tranny with a jetwash or similar give it a run to help determine the exact area it could be running down from above. ie. speedo transducer if its at the 2 housings join together then the only proper way is to strip it down and reseal the 2 castings using the correct sealant/gasket from memory the casings distort with heat from the torque convertor and gives your problem .good luck
SOURCE: transmission flush - 2000 Honda Accord
cheaper than burning the trany trany oil is not change often dont make the mistake hope it help fixya our post thanks pierre
SOURCE: i have an 86 honda
There are two slots in the valve cover right by the cam shaft sprocket that have to be honda bonded or black rtv. look closely at the valve cover right above the gasket underneath the timing belt cover. Hope that helps.
SOURCE: Connector for Speed Sensor on1996 Honda Accord Auto Trans.
If you are talking about just plugging into the speed sensor yes. A VTEC and NON-VTEC are one and the same.
SOURCE: "is there a plug to drain tranny fluid on a 94 accord with auto
You must either drop the pan or have a transmission flush performed. The filter is only a screen so most people use a transmission flush for this issue.
SOURCE: antifreeze leak
If it is leacking on to the trans then most likely is not the water pump as the water pump is in the opposite side of the the trans under the timing cover. Look well for a leaky hose, radiator, bypass and heater hose. Also look at the thermostat housing which is at the end of the hose that goes over the trans, starter and onto the side of eng.
336 views
Usually answered in minutes!
×