On that one it actually called circuit opening relay under left side of dash in fuse relay box
1. There is a fuel pump test connector (Located near the firewall below the windshield wiper motor) Energize fuel pump by bridging (jumping) the terminals of the yellow fuel pump test connector, and turning ignition "ON".
2. fuel pressure 64-85 psi (441 - 589 kPa)
3. if fuel pressure is higher, replace pump
4. if pressure is lower then minimum check fuel filter, if filter is ok, replace pump
5. Start Engine fuel pressure 27-33 psi (186-225 kPa)
6. Engine running remove vacuum hose from fuel regulator fuel pressure should increase 34-40 psi (235-275 kPa)
7. if not, replace fuel regulator
8. Shut Engine "OFF" wait 5 minutes pressure mMinimum 21 psi (147kPa)
9. If not, check for leaking fuel injector(s). If injectors are not leaking, replace pressure regulator
10. relay is located under hood in the relay on top
I have diagram if want, need email address to send to
Car only starting when you spray easystart, after engine has been switch offf, it will not start. Is there a knock or cut off switch cutting in, to stop engine starting.
SOURCE: I have been told that I need to replace my fuel
located under the drivers dash heres a picture to help aid you. hope this helps
4,211 views
Usually answered in minutes!
I want to unplug it, to release fuel pressure because I want to change fuel filter.
I want to unplug it, to release fuel pressure because I want to change fuel filter.
what does this relay do?
where are the freeze plugs located in a 1988 mx6
×