My 94 chevy truck stalls even at highway speed ,it starts again but stalls after a few secs, finally it will run for awhile before it stalls again
SOURCE: 02 SENSOR
For a lot of engines (as long as they are not inlines), have 2. One just after where the exhaust manifold pipes meet up with the collector tubes. there is usually 3, one in each cylinder bank upstream from the cat and one after the cat if there is two cats, like the 96 and up full size V8, there are 4 total sensors
SOURCE: Where is the crankshaft sensor located on a 02
its on the front of the block towards the bottom should only be one bolt holding it in not difficult just not much room to play with
SOURCE: where are the knock sensors located on a 02 chevy
It is usually below the the cylinder head on the passenger side towards the back of the engine. It has a white single mushroom shaped connector.
SOURCE: were is the crankshaft position sensor located on 2001 chevy mali
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
SOURCE: location of crankshaft sensor for
The crankshaft position sensor is located on the top rear center of the engine near the bell housing.
Hope this helps.
1,638 views
Usually answered in minutes!
×