How to remove a serpentine belt on a 94 integra

a serpentine belt ( multi groove ) is used to drive the assecories such as alternator .water pump, power steering etc all togeather and is tensioned by an adjustable idler pulley. So the answer to this is no.If you care to look under the bonnet of several other cars you will see the difference

You'll need a Serpentine Belt Tool and a socket set.

Rotate the Caravan's serpentine belt tensioner assembly clockwise to relieve the tension on the belt. Slip the belt off the tensioner with your free hand before rotating the tensioner back to its home position. Remove the tool.
Extract the two mounting bolts that hold the serpentine belt tensioner assembly to the Caravan's front engine cover using your socket set. Depending on your physical size and dexterity, you may find this easier to accomplish through the top of the engine well or through the passenger-side wheel well.
Pull the old serpentine belt tensioner assembly out of the Caravan's engine bay by hand. Place the new serpentine belt tensioner assembly on the Caravan's front engine cover and bolt it in using your socket set.
Rotate the new serpentine belt tensioner assembly clockwise with the serpentine belt tool and then place the belt on the pulley by hand. Rotate the new serpentine belt tensioner assembly back into place. Remove the tool and close the hood.

Here a diagram to help you with your belt installation piston #1 top dead center

Here's a link to the serptentine diagram for our '94 Olds 88 Royale...

http://www.gates.com/common/part_locator/view_diagram.cfm?id=S6005

Below is the diagram you requested. Please remember to return to rate this answer and thanks for using Fixya!

94 Chrysler T+C serpentine belt

find the nearest auto parts store and buy a serpentine belt removal to for gm vehicle and apply pressure to the the tentioner and release the belt should come loose by just sliding it off---note--note the position of the belt when replaceing

1. Disconnect negative battery cable and remove coolant reservoir.
2. Remove serpentine belt. Refer to Drive Belts, Mounts, Brackets and Accessories / Drive Belt. See: Drive Belt\Service and Repair
3. Remove two generator bolts.
4. Remove power steering pump and position aside.
5. Remove tensioner bolts and tensioner.
6. Reverse procedure to install, Torquing tensioner bolts to 37 ft. lbs.

Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

The serpentine belt routing should be labeled on your radiator shroud. Look around the engine compartment like the hood or radiator fram suport and there should be a label with the the belt routing.
Good luck and hope this helps

Hope this helps

Mike