This is on a 2005 trailblazer. I can pull a P0014 code along with a Camshaft sensor code (Can't remember that code). But the cruise will not work. Any suggestions?
DTC P0014 Exhaust Camshaft Position (CMP) System Performance.
The cam phasing system is a hydraulically actuated phase shifting mechanism. The powertrain control module (PCM) supplies the ignition positive driver and ground circuits. A pulse width modulated (PWM) driver controls the amount that the camshaft actuator solenoid assembly advances or retards the exhaust camshaft. The exhaust camshaft is commanded to a maximum ****** position of 25 degrees. When the exhaust camshaft is retarded at the maximum rate, the duty cycle of the signal is at 100 percent. The maximum advance rate has a 0 percent duty cycle. Other than when the camshaft is at full advance, a 50 percent duty cycle is used to maintain a steady ****** angle.
Remove Cam Phaser Solenoid and inspect it to ensure that all 3 screens are intact. Chances are you will need to replace this Solenoid and change the oil immediately.
1,644 views
Usually answered in minutes!
×