I am trying to replace the front right passenger side head light buld on my 2009 Kia Spectra.
First I unscrewed the plastic cover / unplugged the electrical wire to the bulb / Removed the screws that held the retaining clip in place / removed the burnt out bulb / put a new bulb back in / but I can not figure out how to line up the retaining clip.
After removing the two screws that hold the retaining clip in place I cannot figure out how to line up the retaining clip so it will hold the light bulb in place. It is at an angle that I can not figure it out.
Can anyone tell me how to line up the retaining clip or remove the entire head light assembly ?
SOURCE: why did the service light for my 2009 kia spectra
Probably because no one is sitting in the passenger seat. If it stays on when someone is sitting in the seat then you may have a problem with the sensor in the seat.
SOURCE: head light 2004 Kia Sedona
Its made like a diaper pin. push in and slide it over a lil bit. (kinda hard to explain )
SOURCE: How to replace top (3rd) brake light on Kia Optima 2007
This answer makes a mountain out of a mole hill! There are two screws directly under the light accessible from the trunk (in two hole, the wires come out of one of them)- just unscrew and you can manuever out without taking off the whole back panel.
SOURCE: can't get passenger side marker light out on a 2007 kia spectra
There is one bolt on top of the radiator support and another in back. The assy fits into a pluug that keeps it aligned so it cam be tough to remove. Just wiggle it side to side while pulling and it'll slowly come out.
Are you looking to fix the bulb that is in the corner of the headlamp? You don't need to remove the head light for that. The is a black cap that screws off just beind it.
SOURCE: warning light is a exclamation with parenthese
The computer has detected an issue with your brakes. Bring it to a dealer and don't drive it as your brakes could fail
662 views
Usually answered in minutes!
×