Abs light on brake pads are new disk also replaced stil light shows on

Only if the warning light showed on the dash...most often these abs sensors get clogged with brake dust or dislodged during wheel swaps if the pads are fine and fluid level correct...first check the brake pads then the disks and clean the sensors with an old toothbrush and reseat, also check the fluid level on the abs system.this should clear warning light.but any error codes stored on ecu need to be cleared using obd.

Interesting question. The ABS magnetic sensors on each wheel can get gummed up with dirt, rust and brake dust. Perhaps the brake shop did not clean the sensor properly, or worse, may have damaged one or more when the rotors are replaced. The sensor also has a tough wire up to the chassis. If this is damaged or disconnected, the ABS light will turn on.

Take it back to the shop and have them check.

Because the problem is not with pads and/or calipers. If the lights come on only when you brake, you may have a light bulb out. If they come on when you start the car and they stay on, you have a problem with your ABS system (anti-lock braking system). The systems self-check when you start the car, so the light should come on and then go out. If it comes on and stays on, the ABS system has failed. You need to have the vehicle serviced to repair the ABS system.

is it the abs light or the brake light there is a low fluid level sensor it is the same light as if the parking brake was on the other actual abs light could be a speed sensor

if it happened after pad replacement check the pad wear sensors

Hi, If you have ABS system the (check light) will be on. You may want to check ABS system.(sensors, computer codes) Have it check out by a professional. Good luck.

abs light could be brake pads need replacing/sensor gone.check pads NOW...18th of an inch is too low.... radio is telling you to wait until it will take the correct code (inputted wrong the last time)

a speed sensor on the front,have the ABS system scaned for the codes(this will show you wich sensor is bad)

If While Installing CV Joint you Failed to Disconnect Wheel Speed Sensor FOR ABS System, It is Possible The wire got stretched and broke off INSIDE Outer Wire Insulter. OR Just Totally UNKNOWINGLY Broke it or Disconnected it. OUTER CV Joint? Match up PERFECTLY? Sense Light came on After Repair to THAT Particular side Concentrate on INSPECTING That side, for A 2 Wire Wrapped as 1 May be a Plug Just inside the Engine Compartment, Coming FROM Wheel well with a 2nd Plug There 1st Plug Being AT The SAID Wheel Backing Plate. Upon Discovery of Problem Reset Light at A Service Center OR Just Disconnect NEGATIVE Battery Cable for 1 minute. Again no doubt that WhEEL's Part Of the ABS Circuitry was Disrupted
I'm in Great Hopes you Find this as Helpfull Information and it assists you in Correcting your Problem. Have a Great Day,
RejakWilson