I cant seem to be able to turn on my fog lights on my 2000 mercedes c200 kompressor..HELP!

Think you will have too pay for this ,although you could try direct connect file sharing ,the programme for which you can download free from www.sourceforge.net ,but to join a hub for sharing you will need to have plenty on your computer to share like films and music ect

- Check the wiring harness for proper connections.
- Check for short circuits.

Does this only occur when the fog lights are on? If so it is a rear fog light. If you have someone step on the brake pedal it will get brighter!

The transmission is sealed and has no fill point, see the dealer for service and adding of fluid.

Can you tell us exactly what happens ? Does it turn over at all ?

In your particular Mercedes Benz C200 compressor don't have a timing belt, don't bother about that it's drive by timing chain, no need to replace without any problem,

i have a Mercedes Benz C200 Kompressor , I just changed the plugs, air filter and oil filter and put new oil, but it's now miss firing badly can some one out there help?

In your car Electronic Stability Program system included many different sensors (yaw-rate sensor, steering angel sensor, body acceleration sensor, some more) if ESP visit Workshop message appear on your instrument display It's very hard to say witch sensor could be the fault without right diagnose most common faults are either steering angel sensor or yaw-rate sensor might be some other sensors if you replace yaw-rate sensor it's need to be calibrate by diagnose computer, if replace steering angle sensor it's need to do right way otherwise when you tern steering wheel fully left or right it will brake at first time then you have to be replace another one so like to advise you to get right diagnose and repair buy Mercedes specialist if do some thing wrong it's be more cost to you if you get right place to do it only you have to pay once.

MERCEDES C200 Kompressor 2001. battery alternator visit workshop is flashing on trip computer. i have replaced alternator. everything is ok. battery getting charge... i cant see any thing wrong so why workshop flashing?? maybe something wrong with new alternator 4 exampel voltage sensor??

the key's are special order and they are fairly expensive. Test the voltage in your remote batteries. They should be 3 volts. These systems are very voltage senstive and require a good battery to operate properly. I'm assuming you have the original batteries in the remote now and it is 6 plus years old. These batteries generally last 3 years so it is definatly time if you have not replaced them yet!