My 1994 Jeep Grand Cherokee went into to security shutdown?

Generally you can clear that by locking and unlocking the drivers side door using the key. Also try hatch lock and sometimes passenger side (rarely but sometimes used).

lock with key,electric door lock button,or remote and alarm will set. to disarm you have to use the key or remote to open it.the reason it woulnt disarm from drivers door is either the door lock cylinder switch is broken or the wire to it in the rubber boot that connects the door and the body is broken.
the remotes are cheap and programing is easy,procedure in owners manuel something like lock drive door with elkect. lock switch with door open then push and hold unlock untill doors unlock then turn key off.you may have to fix that drive door lock cyl.switch first though mabee not dont know for sure

try using the key on the passenger side.

93 jeep grand cherokee limited only have ignition key and changed battery and now security lights and headlights wont quit flashing help!

It will only lock all doors, but should only unlock passenger door.

in the 1994 jeep the anti theft device can be over riden by using key lock/unluck back hatch open and close, then start engine as usual. each time u lock or disconnect battery u must do it again.

Sounds like the actuator went out. There normally run 40-60 for the part and does not take long to replace normally 30 minutes.

I have a 5.2L V8 Jeep Grand Cherokee and i know to reset my security system i actually have to go around to the passenger side door and lock and then unlock it again. Seems fairly odd but that's how i was told it was reset. Give it a go and lemme know!

The ignition security on/off is located at the trunk lock. unlock and lock rear gate and the alarm will turn off. My jeep sat in my drive for a month before a jeep tech told me this. It still triggers the security sometimes when I unlock the passenger door with the key and I go straight to the rear gate lock and it shuts off instantly.