2006 dodge caravan, 6 cyl. relaced cole, sparkepugs and wires in oct. 2009. Engine is reading #2 cyl. misfire again. Why

If it’s the same liter engine for example 3.5 . They offered a 4 cyl and a 6 cylinder as long as they are the same liter they will swap.

2005 Dodge Grand Caravan 3.8L engine misfire on cylinder 5.

answers.edmunds.com > Edmunds Answers

Aug 14, 2012 - MIL on; cylinder 5 misfire; most noticeable at idle in gear ... This could be caused by an EGR valve that is sticking partly open and not closing ...

OBD-II Trouble Code: P0305 Cylinder 5 Five Misfire Detected

www.obd-codes.com/p0305

A P0305 code means that the the car's computer has detected that one of the engine'scylinders is not firing properly. In this case it's cylinder #5.

ODB Code P0305- Misfire in #5 Cylinder - 2008 Dodge ...

repairpal.com > ... > Grand Caravan > 2008 Dodge Grand Caravan

Feb 22, 2011 - ... do something with a misfire in the #5 cylinder of my V6 4.0L engine. ... ODB Code P0305- Misfire in #5 Cylinder on 2008 Dodge Grand Caravan .... My2005 dodge grand caravan jerks when it shifts into gear what could it be.

My Dodge Grand Caravan has a Cylinder 5 Misfire,? ' Yahoo An

1. Traction Control System Problems - Car Forums and Automotive Chat ...

   www.automotiveforums.com > ... > Toyota > SequoiaTraction Control System Problems Sequoia Car Forums. ... The VSC/ATRAC indicator lights are staying on and the system will inadvertantly ..... giving a bad reading following the replacement of the steering angle sensor with a new one.

Hi , could you supply the correct engine code and vin number ?
For the engine code (EKG) the firing order is 1-6-5-4-3-2
For the engine code (EGH) the firing order is 1-2-3-4-5-6

Thats exactly what it sounds like.

good question, most likly a spark plug or wire. but it might be a coil , to test it remove the plug wire from the coil and crank the engine there should be a good strong splrk if there is replace the plug and wire if not replace the coil.

Thanks for using FixYa.

v-6




4-cyl

It could very well be a bad coil pack,or you have low compression in that cylinder.If the compression is good then go with the coil pack,if not you may need a head gasket or an intake manifold gasket.

------>>>FRONT>>>>of Van >>>>

______________________________
#5 cyl #6 cyl

#3 cyl #4 cyl

#1 cyl #2 cyl
______________________________
_________________
I COIL BLOCK I
I I
I #3 #1 #5 I
I I
I I Firing Order Is
I I 1 2 3 4 5 6
I #6 #4 #2 I
I _______________I_

the Wires Go Accordingly to prospective Terminals, So Sorry Unable to Send Pics through FixYa, A Formating Problem Exists
and they show on my end but not on your end this is TRUE and CORRECT To The BOOK other than the Lines from Coil to Spark Plug ENDS at CYLINDERS. Please dont Forget to RATE Me
Thank You And Happy Motoring!!

we get remans bad out of the box......... good luck