2000 Nissan Maxima Logo

Related Topics:

Posted on Nov 27, 2017

I have a nissan maxima 2000 GLE.I replaced the kick starter after which the car was not running well.I was told to replaced the fuel pump,changed the six plugs with new one. But yet the car isn't running well. The car now consume more gas and when its running, it runs as if some of the spark plugs are soaked. please, help.

5 Related Answers

Anonymous

  • 1010 Answers
  • Posted on Jun 17, 2008

SOURCE: spark plugs

Enter to nissan web-site, there is a lot of manuals there.

Ad
A

Anonymous

  • Posted on Jul 09, 2008

SOURCE: starter 2000 maxima se

www.cardomain.com/ride/2076435

pal03246

Phil Lovisek

  • 726 Answers
  • Posted on Jul 19, 2008

SOURCE: Need to locate oil filter in my 2000 Nissan Maxima GLE

Filter is next to the right tire (pass.side) behind a splash shield.

Dan

  • 17 Answers
  • Posted on Jan 03, 2009

SOURCE: Tire pressure.

The tire pressures to use are i your user manual that came in the glovebox. If you no longer have this, buy a 20 dollar manual, which I buy for every car I own and it wil tell you.

If you need an answer to get you by, use 35 psi until you find out exactly what it should be. You may even want to stay with this pressure, as most car manuals wil give you temps for winter and summer, and for different driving conditions, when 35 psi will serve you just fine. If you begin to notice your tir wear is not even, take it to a shop and find out what is wrong with it. You will probably need an alignment.

Also many tires wil tell you on the side, the safe tire inflation pressures, but I have found that 35 psi is a good number to run for just about any passenger car.

Dan

Anonymous

  • 416 Answers
  • Posted on Mar 18, 2009

SOURCE: 2001 nissan maxima gle crank no start code p1320...please help

Primary ignition fault. Reasons: Bad distributor cap (most likely) or ignition control module/ignition coil.
Hope that helps
Good Luck

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1helpful
1answer

I have a 2000 nissan maxima gle 3.0 do i have to take out the engine to cjange the timong tensioner it has a rattling sound

Larry, normally engines do not have to be taken out to change timing tensioners, the bumper assy., A/C condenser,radiator,etc is removed to get access. Best if you get yourself a manual.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

DIY Video VQ35DE Timing Chain Tensioner and Water Pump Replacement

NISSAN MAXIMA Timing intro MP4

1995 2001 Nissan Maxima 1 3 Water pump replacement

How to fix timing chain rattle Maxima Forums


0helpful
1answer

Nissan Maxima cooling fans stay on 2000 Maxima GLE The wont cycle off after the engine temp is cooled down, I replaced the Rad.tstat,sensor,relays& pulled the water pump to make sure is it my?

did this just happen ?? Out of the blue ??,,,, sounds as if it is hard wired ,,,,look for any jumper wires attached to the plug on your fan
0helpful
2answers

2000 nissan maxima no start

Check your ignition fuses one may be shot
0helpful
1answer

Where is the starter relay located on a 2000 Nissan Maxima GLE?

should be in the engine compartment fuse box often located near the battery.
0helpful
1answer

2000 maxima gle - will start and idle, put engine dies when give gas. All was fine until I replaced the starter. When I put it back together is when the trouble started. I've checked vacuum hoses and...

Can't really say. But you need to put a fuel pressure gauge on it.
Could be EGR, throttle position sensor, etc., but don't see how the starter could be related.
Have to wonder if you left a wire off or put one in the wrong place.
The main power for the fuel injection and ignition come off the main starter positive. And a cold start wire comes off the starter solenoid.
0helpful
1answer

2000 nissan maxima hard to start.

sounds like solenoid on starter is worn, replace starter.
1helpful
1answer

NISSAN MAXIMA GLE WONT START

To really give you the "right" answer I am going to need a little more information from you.

Did the car run when you gave him the car?
Why was the mechanic changing the fuel pump?

If the car ran when you gave him the car and then after he changed the fuel pump it wouldn't start I would have to say it has something to do with his removal and installation. Or the actual fuel pump itself. Was he installing a brand new or used pump?

He must not have gotten the wires back on the sender or in the wrong order causing the "new" fuel pump to not work thereby making your car not start.

Or atleast something along those lines. Like I said without a little more background I can't give you the exact answer.

Well good luck and I did my best with the information you provided.
Please feel free to give me a good rating,
Thanks and have a great day,
AadoubleA
3helpful
2answers

1998 maxima gle Tune-up needed what parts do i need

Every 30,000 miles you need an air filter, every 60,000 a fuel filter, every 100,000 spark plugs. That's it.
1helpful
1answer

Need to locate oil filter in my 2000 Nissan Maxima GLE

Filter is next to the right tire (pass.side) behind a splash shield.
Not finding what you are looking for?

128 views

Ask a Question

Usually answered in minutes!

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...