SOURCE: Replacing alternator in a 2001 Dodge Intrepid
the easiest way is going to first be to remove the serpentine belt which requires you to loosen the nut on the end of the idler pulley just above the alternator, then behind the pulley is a bolt with a 13mm head on it that you will want to loosen after the pulley is loose to relieve tension off the belt. Remove the belt. Next make sure you remove the battery cables to ensure you dont fry yourself to the car when unhooking the electrical connections from the alternator, your battery is located on the passenger side, down behind and underneath the headlight. Then go under the car and remove the black plastic clips that hold the splash shield up under the bumper. After this the alternator becomes as accesible as it can be, remove it from the bottom. Thanks for using fixya!!
SOURCE: EGR valve
Have a look at this article for some idea of where to look.
http://en.allexperts.com/q/Chrysler-Repair-807/2008/10/Rough-idle-coming-stop-2.htm
SOURCE: 2005 Dodge 1500 code p0404 EGR valve.
The electronic EGR valve and solenoid assembly is attached to the rear of the left cylinder head ,
INSTALLATION
SOURCE: egr valve dodge durango
if this is a 4.7l engine, the valve is on the left rear of the intake. loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time and patience.
SOURCE: how to install egr valve on 2006 dodge grand
You cannot clean them purchase a new one and pull the old one out of the valve cover, and disconnect the hose that runs to it. install the hose on to the new egr with a new worm clamp and push the other end into the valve cover. should take about 10 minutes.
766 views
Usually answered in minutes!
×